Sony KV 36HS500 manual Programming the Remote Control, Press Code SET

Programming the Remote Control

The remote control is preset to operate Sony brand video equipment.

Sony Equipment	Switch Position on	Programmable Code
	Remote Control	Number
Beta, Ed Beta VCRs	AV1	303
8 mm VCR	AV2	302
VHS VCR	AV3	301
DVD player	DVD	751

If you have video equipment other than Sony brand that you want to control with the TV’s remote control, use the following procedure to program the remote control.

✍The equipment must have infrared (IR) remote capability in order to be used with the remote control.

z

❑If more than one code number is listed, try entering them one by one until you come to the correct code for your equipment.

❑If you enter a new code number, the code number you previously entered at that setting is erased.

❑In some cases, you may not be able to operate your equipment with the supplied remote control. In such cases, use the equipment’s own remote control unit.

❑Whenever you remove the batteries to replace them, the code numbers may revert to the factory setting and must be reset.

1Turn to the list of “Manufacturer ’s Codes” on page 44, and find the three-digit code number for the manufacturer of your equipment. (If more than one code number is listed, use the number listed first.)

2Set the A/V slide switch to 1, 2, 3, or DVD.

3Press CODE SET.

4Press the FUNCTION button for the type of equipment you want to control with the TV’s remote control (VCR/DVD FUNCTION or SAT/CABLE FUNCTION).

5Enter the three-digit manufacturer’s code number.

6Press ENTER.

✍You must do step 6 within 10 seconds of step 5, or you must redo steps 3 through 6.

7To check if the code number works, aim the TV’s remote control at the equipment and press the POWER button that corresponds with that equipment. If it responds, you are done. If not, try using another code listed for that manufacturer.

Remote Control SETUP

SETUP

43