Sony KV-32LS65AUS Using Optional Equipment, Symbol Input Signals, For Mono Equipment

Connecting to external Audio Equipment:

Plug in your Hi-Fi equipment to the audio output sockets D if you wish to amplify the audio output from TV. Next , using the menu system, select the “Set Up” menu, enter the “Detail Set Up” menu and set “TV Speakers” to “Off”.

Audio level of the external speakers can be modified by pressing the volume buttons on the remote control. Also treble and bass settings can be modified through the “Sound Adjustment” menu.

To enjoy “Dolby Virtual” sound effect through your Hi-Fi equipment:

Place the speakers of your equipment in front of your listening position and beside the TV set but keeping a distance of 50 cm between each speaker and the TV set. Then by using the menu system, select the menu “Sound Adjustment”. Next select “Dolby Virtual” on the “Effect” option.

Left Hi-Fi	Right Hi-Fi
speaker	speaker

~50°

Using Optional Equipment

1 Connect your equipment to the designated TV

socket, as indicated in the previous page.			Your sitting position
2 Switch on the connected equipment.
3 To watch the picture of the connected equipment, press the				button repeatedly until the
correct input symbol appears on the screen.
Symbol		Input Signals
	1	• Audio / video input signal through the rear connector E.
1		• YUV input signal through the rear connector E.
	2	• Audio / video input signal through the rear connector F.
2		• YUV input signal through the rear connector F.
	3	• Audio/video input signal through the rear connector					and
						G1		G3	.
	S 3
		• S Video Input signal through the rear connector		G2	. This symbol appears
		only if an S Video source has been connected.
	4	• Video input signal through the phono socket B and Audio input signal
		through C.
	S 4	• S Video Input signal through the front S Video input jack A and Audio
		signal through C. This symbol appears only if an S Video source has been
		connected.

4 Press button on the remote control to return to the normal TV picture.

For Mono Equipment

Connect the phono plug to the L/G/S/I socket on the front of the TV and select 4 or S 4 input signal using the instructions above. Finally, refer to the “Sound Adjustment” section of this manual and select “Dual Sound” “A” on the sound menu screen.

EN

Additional Information

19