RCA DTC210 user manual Connections & Setup

Connections & Setup

6.Connect the audio from the DIRECTV® HD Receiver to your monitor.

Connect a pair of RCA-type cables to the AUDIO jacks in the COMPONENT VIDEO section of the back of your DIRECTV HD Receiver. Connect the other ends of the cables to the audio input jacks on the back of your TV, monitor (shown on the previous page) or audio receiver (not shown). Make sure you match the Left (white) output with the Left input and the Right (red) output with the Right input. See page 19 for instructions on how to connect a digital audio receiver to your HD Receiver.

7.Set the DTV OUTPUT switch on the HD Receiver to the Y PB PR setting.

8.Set the RESOLUTION SELECT switch on the front panel.

To watch the DIRECTV HD Receiver on your monitor or TV:

For most RCA, GE or Proscan monitors or TVs:

Press TV on the remote control that came with your HD Receiver. Then press the WHO•INPUT button on the remote until you see the signal from the HD Receiver on your TV or monitor.

For brands other than RCA, GE or Proscan:

Consult your TV Owner’s Manual.

If you cannot find your TV Owner’s Manual, you will have to investigate. You might access the TV’s video input channel by:

•pressing a button on the TV’s remote control, the HD Receiver’s remote control or on the front of the TV (see the box below)

•finding it through the TV’s menu system

•tuning directly to it by pressing a specific channel number (see the box below)

•going through all channels in the list by pressing the channel up or down buttons on the TV (see the box below)