Installation, Master Control Unit MCU, Touchscreen

Product Manual – INTUITION HT

fig. 1 – Master Control Unit

1.Insert a USB cable into the top USB slot in middle rear of MCU (indicated as USB in fig. 1).

2.Insert blue, male-ended VGA monitor cable from the touchscreen into female monitor port on the left rear of the MCU (Monitor, fig. 1).

3.Insert white/grey female-ended serial cable from the switching system into left male serial port (Switching, fig. 1).

4.Insert red and white male RCA cables into same color ports (Audio, fig. 1).

5.Insert power cable into power port (AC, fig. 1).

1.Insert a USB cable from the MCU into the USB slot on the bottom of the touchscreen (circled in fig. 2).

2.Insert blue, male-ended VGA monitor cable from the MCU into female monitor port on the

bottom of the touchscreen.

3.Insert power cable into power port.

1.Insert white/grey female-ended serial cable from the MCU into the interface board connected to your MTI switching system. (fig. 3)