RCA RCA manual SETTING/RESETTING the Attract Loop, ENABLING/DISABLING Products

Product Manual – INTUITION HT

SETTING/RESETTING THE ATTRACT LOOP

There are two configuration options for the attract loop. You can set whether you want to password-protect the attract loop (i.e., password is needed to initiate a session, thus requiring an employee to walk the customer through the experience). You can also set the inactivity timeout (i.e., the length of inactivity time before the system switches back to the attract loop).

The system is shipped with no password protection on the attract loop and the inactivity timeout is set for 3 minutes. If you want to change these settings:

1.From the Manager Control Panel, touch Set/Reset Attract Loop.

2.Select Set/Reset Password if you want to password- protect the attract loop. Follow on-screen instructions to create a password. The password you select only applies to the attract loop and does not affect the manager mode password.

3.Select Set/Reset Inactivity Timeout to change the timeout settings. Select the desired timeout length. (fig. 9) Select No Timeout if you want to disable the timeout feature. The system notifies that the timeout has changed.

ENABLING/DISABLING PRODUCTS

There may be times when you need to disable a product in the display (e.g., product is temporarily unavailable because it has been sold/removed from the display) and then later re-enable it. To enable or disable products:

1.From the Manager Control Panel, touch Configure Positions.

2.Select a product category (e.g., A/V Receivers) from list on the top.

3.Touch the component number you want to disable. When a product is disabled, a red X appears instead of the product number. (fig. 10) Touch the number again when you want to re-enable the product.

MODIFYING GOOD, BETTER, BEST

Use this option to modify the components that comprise the pre-configured systems (i.e., Good, Better, and Best).

1.From the Manager Control Panel, touch the Modify Good, Better, Best button.

2.Select package you want to modify (e.g., Best).

fig. 9 – Inactivity Timeout screen

fig. 10 – enable/disable product

fig. 11 – Modify Good, Better, Best screen

3.A new screen appears showing the current components for this system. (fig. 11) To modify this system, select the product category you want to modify from the list on the top (e.g., A/V Receivers).

4.Select a new component to add it to the package.

5.After you have made all selections, touch the Submit Change button.

8