RCA RCA manual Configuring Chains Super User Mode only, Number of products in the display

Product Manual – INTUITION HT

CONFIGURING CHAINS (SUPER USER MODE ONLY)

This feature allows you to configure and test the system so that the display’s user interface (component categories and products that the customer sees on the display screen) matches the products in the display.

Note: This option is only available if you have logged into the Super User mode (see “Accessing the Manager Control Panel” section above).

1.From the Manager Control Panel, touch the Configure Chains button.

2.Press the Enable/Disable button to enable or disable a chain. If you enable a chain, the product category (e.g., A/V Receiver) will be shown on the system selector screen. (fig. 12) If you disable a chain, the product category is not included on the system selector screen and is not available to the customer.

3.Use the +1 +5 -1-5buttons to set the number of products in each category. For example, if there are eight A/V receivers in the display, set the # of positions to 8. When a customer selects A/V Receivers on the system selector screen, they will now see eight products (represented by numbers 1 – 8). (fig. 13)

4.Press the Test Chain button if you want to test all positions in a chain. For example, if you press the Test Chain button for A/V Receivers, the system will cycle through all A/V receiver positions (in numerical order) turning each receiver on and off. This feature helps confirm that the display is wired and configured correctly.

number of products in the display

Disable will remove category from the system selector screen

Tests all product positions in the chain

used to change the number of products

fig. 12 – Configure Chains screen

9