Basic playback, Changing audio channels | Pioneer DVR-510H specification

Getting started

• SMART JOG on the front panel

Note

•Antenna channels are numbered 2 through 69. Cable channels are numbered 1 through 125.

•You can’t change TV channels during playback (from DVD or HDD) or recording, or while in recording standby.

Changing audio channels

Some TV programs are broadcast with both a main and a Second Audio Program (SAP). You can change the TV audio using the AUDIO button.

AUDIO

•Press AUDIO to change the TV audio.

The current audio channel is displayed on-screen.

Mono SAP

Stereo

•If SAP is selected, but there is no SAP channel being broadcast, you will still hear the main audio channel.

•If the sound is poor quality when set to Stereo, you can often improve it by changing to Mono.

Basic playback

This section shows you how to use your recorder for playback of discs (DVD, CD, etc.), and for playback of video from the HDD. More playback features, such as repeat and program play, are covered in the next chapter.

Important

•Throughout this manual, the term ‘DVD’ means playback-only DVD-Video discs and DVD-R/RW. If a function is specific to a particular kind of DVD disc, it is specified.

•Some DVD-Video discs don’t allow certain playback controls to operate at certain points in the disc. This is not a malfunction.

STANDBY/ON

OPEN/CLOSE

ENTER

PLAY

STOP

1 Press STANDBY/ON to switch on.

Also turn on your TV and make sure that it is set to the correct video input.

2 Select HDD or DVD for playback.

Use the HDD and DVD buttons on the remote, or the HDD/DVD button on the front panel.

If playing video from the HDD, skip to step 5 below.

3 Press OPEN/CLOSE to open the disc tray.

4 Load a disc.

Load a disc with the label side facing up, using the disc tray guide to align the disc (if you’re loading a double- sided DVD-Video disc, load it with the side you want to play face down).

•If you want to play a DTS audio CD, please first read the note on page 29.

5 Press PLAY to start playback.

•If you’re playing a DVD-Video or Video CD, a disc menu may appear when you start playback. Use the

(cursor) buttons and ENTER to navigate DVD disc menus, and the number buttons and ENTER for Video CD menus.

•See the following sections for more details on playing specific kinds of discs.

6 To stop playback, press STOP.

7When you’ve finished using the recorder, eject the disc and switch the recorder back into standby.

• To open/close the disc tray, press OPEN/CLOSE. Remove the disc before putting the recorder into standby.