Pioneer DVR-510H manual Selecting the hard disk or DVD for playback and recording, Enter

Getting started 04

Use the (cursor up/down) buttons to select

Compatible, Not Compatible, or Don’t Know, then press ENTER.

•Note that progressive scan video is only output through the component video outputs (see page 14).

9Is this recorder connected to an AV receiver for digital audio?

Initial Setup
Basic	Clock AV Amp Digital Connect
Tuner	On
Video Out	Front	Connected
Audio In	Remote
Audio Out	Setup	Not Connected
Language
Recording
Playback

Use the (cursor up/down) buttons to select

Connected, or Not Connected, then press ENTER.

•If you select Not Connected, that completes the setup. Press ENTER to exit the Setup Navigator, or select Go Back if you want to go back and start again.

10Select the digital audio formats your AV receiver is compatible with.

Initial Setup
Basic	Clock AV Amp Compatibility
Tuner	On
Video Out	Front	Dolby Digital
Audio In	Remote
Audio Out	Setup	Dolby Digital,DTS
Language		PCM only
Recording
Playback

Use the (cursor up/down) buttons to select Dolby

Digital, Dolby Digital, DTS or PCM only, then press

ENTER.

•Check the operating instructions that came with your AV receiver if you’re not sure what it’s compatible with.

11Is your AV receiver compatible with 96 kHz digital audio?

Initial Setup
Basic	Clock	96kHz PCM Compatible
Tuner	On
Video Out	Front		Compatible
Audio In	Remote
			Not Compatible
Audio Out	Setup
Language			Don't Know
Recording
Playback

12That’s it! Press ENTER to finish setting up, or select ‘Go Back’ if you want to start again.

Initial Setup
Basic	Clock
Tuner	On	Setup is complete!
Video Out	Front
		Enjoy using your DVD recorder!
Audio In	Remote
		Finish Setup
Audio Out	Setup
Language		Go Back
Recording
Playback

Other settings you can make

After setting up using the Setup Navigator, you should be ready to start enjoying your DVD recorder. It’s possible, however, that you may want to make a couple of additional settings, depending on how the recorder tuned into the terrestrial TV channels.

•Manual channel setting – This setting lets you skip channels where there is no station, as well as manually tune to stations. See Manual CH Setting on page 91.

•VCR Plus+ channel setting – This setting lets you assign guide channels to ensure that the VCR Plus+ programming system works correctly. See VCR Plus+ CH Setting on page 91.

That completes basic setup using the Setup Navigator.

•Setting up the remote to control your TV – You can set up the supplied remote control to control many brands of TV. See Setting up the remote to control your TV on page 101.

Selecting the hard disk or DVD for playback and recording

The HDD and DVD buttons on the remote control and the HDD/DVD button on the front panel are used to select the hard disk (HDD) or DVD for playback and recording. The indicator in the front panel display shows which is currently selected.

HDD DVD

Use the (cursor up/down) buttons to select

Compatible, Not Compatible, or Don’t Know, then press ENTER.

• Check the operating instructions that came with your AV receiver if you’re not sure.

25

En