Pioneer SC-35 manual Using other functions Using the sleep timer, Dimming the display

Using other functions 09

Using the sleep timer Using the Web Control function

The sleep timer switches the receiver into standby after a specified amount of time so you can fall asleep without worrying about the receiver being left on all night. Use the remote control to set the sleep timer.

•Set the remote control to the receiver operation mode, then press SLEEP repeatedly to set the sleep time.

30 min		60 min
	Off	90 min

•You can check the remaining sleep time at any time

by pressing SLEEP once. Pressing repeatedly will cycle through the sleep options again.1

Dimming the display

You can choose between four brightness levels for the

front panel display. Note that when selecting sources, the display automatically brightens for a few seconds.

•Set the remote control to the receiver operation mode, then press DIMMER repeatedly to change the brightness of the front panel display.

Switching the HDMI output

Set which terminal to use when outputting video and audio signals from the HDMI output terminals.

The HDMI OUT1 terminal is compatible with the Control with HDMI function.

The receiver can be operated using a browser from a computer connected on the same LAN as the receiver.

1Turn on the computer and launch the Internet browser.

2In the address bar on the browser, enter the IP address assigned to this receiver.

For example, if the IP address of this receiver is “192.168.0.2”, enter “http://192.168.0.2/”.

When the connection is made with the receiver, a Top Menu will be displayed.

This receiver’s IP address can be found in the ‘IP address, Proxy’ menu (page 117).

3Once the Top Menu is displayed, click the button for the zone you want to operate.

4Operate from the screen for the individual zone.

•Even when the receiver is in the standby mode, it can be turned on using the Web Control function. For details, see Network Standby on page 118.

					Top Menu
Web Control
Main ZONE			ZONE 2		ZONE 3
POWER	ON	OFF	VOLUME	-60.0dB	MUTE
INPUT SELECT	DVD
LISTENING MODE	STEREO
AUTO SURR/ALC/	HOME		STANDARD	ADVANCED	STEREO
STREAM DIRECT	THX		SURROUND	SURROUND

•Set the remote control to the receiver operation mode, then press HDMI OUT.

Please wait a while when Please wait ... is displayed.

The output switches among HDMI OUT ALL, HDMI OUT 1 and HDMI OUT 2 each time the button is pressed.2

Checking your system settings

Use the status display screen to check your current settings for features such as surround back channel processing and your current MCACC preset.

1Set the remote control to the receiver operation mode, then press STATUS to check the system settings. The front panel display shows each of the following settings for three seconds each: Input function, Sampling Frequency, MCACC preset, ZONE 2 input, ZONE 3 input and HDMI OUT.

2When you’re finished, press STATUS again to switch off the display.

Note

1 The sleep timer is valid for all zones. If any zone is on, the sleep timer continues functioning.

2• The synchronized amp mode is canceled when the HDMI output is switched. If you wish to use the synchronized amp mode, switch to HDMI OUT 1, then select the synchronized amp mode on the TV using the TV’s remote control.

• When the power is turned off then back on after switching the HDMI output, the input is set to a setting between HDMI1 and HDMI3, or BD.

81

En