Pioneer SC-35 manual Additional information, Troubleshooting, Power

13Additional information

Tip

•The distance to the subwoofer may be slightly larger than the distance actually measured with a tape measure, etc. This is because this distance is corrected for electric delay, and is not a problem.

Positional relationship between speakers and monitor

Position of front speakers and monitor

The front speakers should be as equidistant as possible to the monitor.

TV

L R

45° to 60°

Position of center speaker and monitor

Since mostly dialogs are output from the center speaker, keeping the center speaker as close as possible to the screen makes the overall sound more natural. For TVs using Braun tubes, however, when installing the center speaker on the floor, adjust its angle of elevation to point it towards the listening position.

Installation on floor(Diagram as seen from the side)

Monitor

•If the center speaker is not of the shielded type, install it away from the TV.

•When installing the center speaker on top of the monitor, place it facing slightly downwards towards the listening position.

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer authorized independent service company to carry out repair work.

Note

•If the unit does not operate normally due to external effects such as static electricity disconnect the power plug from the outlet and insert again to return to normal operating conditions.

Power

Symptom	Remedy
The power does not turn on.	• Make sure that the power cord is plugged in to an active power outlet.
	• Try disconnecting from the power outlet, then plugging back in.
	SC-37 only:
	• When remote control operation is set to RF two-way communications, the receiver’s power cannot
	be turned on unless RF Remote Setup is set to ON (see RF Remote Setup (SC-37 only) on page 120).
	• When remote control operation is set to RF two-way communications, check whether the RF
	adapter is properly connected to the receiver.
Power cannot be turned off.	• Set the remote control’s MULTI-ZONEoperation selector switch to ZONE 2 or ZONE 3, then press
(ZONE 2 ON or ZONE 3 ON is	 RECEIVER to switch the sub zone off.
displayed.)
The receiver suddenly switches	• Check that there are no loose strands of speaker wire touching the rear panel or another set of
off or the iPod iPhone	wires. If so, re-attach the speaker wires, making sure there are no stray strands.
indicator blinks.	• The receiver may have a serious problem. Disconnect from the power and call a Pioneer authorized
	independent service company.

122

En