RCA L26HD35D, L32HD35D owner manual Power source, Inserting Batteries, Operation, To USE AC Power

Page 12

Remote control

 

 

(continued)

Inserting Batteries

Install two “AAA” batteries,

3

Replace the compartment cover.

 

Open the battery compartment

1 cover in the direction of the arrow.

2 paying attention to the

 

 

 

polarity diagram in the battery

 

 

 

compartment.

 

 

Operation

 

 

 

•

Aim the remote control at the remote sensor and press control

 

 

•

buttons to operate.

 

 

 

Operate the remote control within a 30° angle on either side of

Approximately 15 feet

 

the remote sensor, up to a distance of approximately 15 feet.

 

 

 

NOTE:

 

 

 

•

Do not leave the remote control unit exposed to direct sunlight or in hot or humid places.

•

The remote control unit uses infrared beams to transmit signals, so sunlight or fluorescent light on the remote

•

sensor may shorten operating distance.

 

 

Incorrect use of batteries may cause them to leak or burst. Read the battery warnings and use the batteries

•

properly.

 

 

 

Do not mix old and new batteries.

 

 

 

•

Remove batteries if the remote control will not be operated for an extended period of time.

Power source

TO USE AC POWER

1. Connect the AC cord plug into this unit’s AC IN jack.

2. Connect the AC cord into an AC outlet.

AC Outlet

Wider Hole

and Blade

AC 120V, 60Hz

AC cord (supplied)

NOTE:

• Please make sure to insert the cord securely at both the LCD TV/DVD and the wall outlet.

• The AC Cord has a grounding-type AC line plug. If the supplied AC cord does not match your AC outlet, contact a qualified electrician, do not defeat the purpose of a grounding plug.

WARNING:

• DO NOT CONNECT THIS UNIT TO THE POWER USING ANY DEVICE OTHER THAN THE SUPPLIED AC CORD. THIS COULD CAUSE FIRE, ELECTRICAL SHOCK, OR DAMAGE.

• DO NOT USE WITH A VOLTAGE OTHER THAN THE POWER VOLTAGE DISPLAYED. THIS COULD CAUSE FIRE, ELECTRICAL SHOCK, OR DAMAGE.

CAUTION:

• WHEN THIS UNIT IS NOT USED FOR A LONG TIME, (E.G., AWAY ON A TRIP) IN THE INTEREST OF SAFETY, BE SURE TO UNPLUG IT FROM THE AC OUTLET.

• DO NOT PLUG/UNPLUG THE PLUG WHEN YOUR HANDS ARE WET. THIS MAY CAUSE ELECTRICAL SHOCK.

• IF YOU NEED TO REPLACE THE SUPPLIED AC ADAPTER OR AC CORD, THE SPECIFIED ONE IS RECOMMENDED. CONTACT THE DEALER THAT YOU PURCHASED THE UNIT FROM.

12

52K0101A_eng.indd 12

3/12/09 3:10:50 PM

Page 11 Page 13
Image 12
Page 11 Page 13
Contents
L26HD35D L32HD35D Product Registration Product Information Location of the required MarkingElectrical Code, ANSI/NFPA 70, provides Information with respect to proper groundingHOW to Handle the LCD Panel Child SafetyIssue Tune Into SafetySafety Precautions Features Digital Audio Jack CoaxialContents Disc Location of controls FrontLeft side Rear side PC Monitor in jackRF ANT in jack Audio L/R jacks For Component in and Line 2 VideoRemote control Power source To USE AC PowerInserting Batteries OperationAntenna connections Jack 75 ohmCoaxial Matching Cable Antenna Jack Combiner UHF 300 ohmCable TV Jack Splitter Switch Ohm Cable to TV Cable TV connectionsAntenna Jack 75 ohm Cable TV JackSetting the on-screen language Memorizing channelsAir/Cable selection EnterCable Chart Automatic searchAdding Channel Clear AllTV operation To select the video input sourceTo Select Analog Channels To Select Digital ChannelsSetting the V-Chip Labeling channelsLabeling video inputs To create channel labelsTo register a password To change the passwordTo set the V-Chip ALLTo clear the all V-Chip settings Press SETUP/TV Menu while on a digital channelClosed Caption Picture control adjustment CC advancedSelecting the color temperature Setting the picture sizeSelecting the picture size NaturalFilm mode Native for PC mode onlyCinema Wide3 for letter box programs with subtitles Full for 169 source programsSound control adjustment Selecting the audio languageSurround Press or to select Audio , then press or 3 EnterTurning off the built-in speakers To turn on the built-in speakersPlayback procedure PowerPreparation Status display of discSpecial playback MP3/WMA/JPEG and Audio CD playbackLimitations on display Press Enter or PlayRotating an image Zooming an imageSetting the Jpeg interval Select FilesYou can continuously play back all Jpeg files automatically OffRepeat playback CD Random playback CDZooming Repeat playbackTo cancel the mark Press Cancel Press Marker to remove this displayReturning to the scenes Press Enter Playback starts from the marked sceneSetting the language Title selectionDVD menu Setting the aspect ratio of TV screen Setting on screen displaySetting the picture mode Night mode Password and settingDigital out Parental controlSetting the new password Temporary disabling of rating level by DVD discLanguage code list Connections to other equipment To connect the LCD TV/DVD to a VCRTo connect the LCD TV/DVD to a VCR with an S-Video cord To connect to a DVD player with Component Video InputUsing an AV Amplifier with built-in digital surround To connect a Hdmi or a DVI device to the unitTo DVI output To PC/DVI TV/DVDTo connect an audio system To connect the TV/DVD to a camcorder, or a TV GameReception disturbances IgnitionProblems and troubleshooting Symptoms Power Possible SolutionsTV Broadcast Reception Poor sound or no soundSymptoms DVD Possible Solutions Remote ControlSpecifications AccessoriesModel GeneralTTE Technology, Inc. TTE Limited Warranty All LCD Models Limited Warranty Memo Memo TTE Technology, Inc West 103rd Street Indianapolis,