: Select 
: Adjust
2 Press ▲ or ▼ to select “Signal Type”, then press ◀ or ▶ to select “Cable” or “Air”.
3 Press ▲ or ▼ to select “Automatic Search”, then press ▶ or ENTER.
4 Now the “Auto Setup” starts. After the starting setup is completed, the TV channel appears on the screen.
•Depending on the reception condition, it may take from 15 minutes to 30 minutes to complete memorizing digital cable channels. Please be patient.
NOTE:
• If you press EXIT/CANCEL in the process of “Auto Setup”, the Starting Setup stops and changes to the normal screen.
• When you make a menu selection, your changes occur immediately.You do not have to press EXIT/ CANCEL to see your changes.
• When you are finished programming the menus, press EXIT/CANCEL.
Setting the on-screen language
You can choose from three different languages (English, French and Spanish) for the
Select the language you prefer first, then proceed with the other menu options.
1
2
3
52K0101A_eng.indd 15
Main Menu
Picture>>
Audio
Channel
Lock
Setup
: SelectENTER:Set
4 Press ▲ or ▼ to select “Setup”, then press ▶ or
ENTER.
5 Press ▲ or ▼ to select “Language”.
Setup
| Closed Caption | >> |
|
| Language | English |
|
| Video Label | >> |
|
| Auto Shut Off | Off | |
| Reset | >> |
|
|
|
|
|
: Select : Adjust
6 Press ◀ or ▶ to select the desired language: English, French (Français) or Spanish (Español).
7 Press EXIT/CANCEL to return to the normal screen.
NOTE:
• If no buttons are pressed for more than about 60 seconds, the menu screen will return to normal operation automatically.
Memorizing channels
This TV is equipped with a channel memory feature which allows channels to skip up or down to the next channel set into memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the TV’s memory. To use this TV with an antenna, set the Signal Type option to the Air mode. When shipped from the factory, this menu option is in the Cable mode.
Air/Cable selection
1 Press SETUP/TV MENU in the TV mode. The TV menu screen will appear.
2 Press ▲ or ▼ to select “Channel”, then press ▶ or ENTER.
3 Press ▲ or ▼ to select “Auto Ch Memory”, then press ▶ or ENTER.
4 Press ▲ or ▼ to select “Signal Type”. 5 Press ◀ or ▶ to select “Air” or “Cable”.
Air - VHF/UHF channels
Cable - CABLE TV channels
Auto Ch Memory
| Signal Type | Cable |
|
| Automatic Search | Start | |
|
|
|
|
: Select : Adjust
6 Press EXIT/CANCEL to return to the normal screen.
15
3/12/09 3:10:52 PM