Chapter 1: Connections and Setup
Installing TV on Suspension Arm - J12H770-DV3 / J12H770-DV4
The J12H770 is designed to attach to a wall mounted suspension arm capable of supporting a television weighting 14 pounds. The single coaxial cable on top of the unit is used to supply either low voltage DC power (24 volts) and the RF signal to the television.
Male RF Cable
Female 3.5mm Stereo Cable (RS232C)
Male 3.5mm Cable
(Y, Pb, Pr)
Male DC 5V Jack
Male 3.5mm Cable (Audio)
DANGER: ARM RECOIL HAZARD The safety brake pin must remain in the SAFETY BRAKE PIN HOLE whenever the television set is removed from the arm or when the arm is removed from the wall bracket to prevent the arm from springing open.
CAUTION: DO NOT REMOVE the Beige silicon cover from the swivel assembly. This swivel assembly is factory preassembled and adjusted. There is no need to remove the cover.
IMPORTANT: These instructions detail installing the TV onto the
Chapter 1 | 11 |