Chapter 1: Connections and Setup
"User must use shielded signal interface cables with ferrite cores to maintain standard compliance for the product"
Things to Consider Before You Connect
Protect Against Power Surges
•Connect all devices before you plug any of their power cords into the wall outlet or power strip. NEVER plug your TV into an outlet that is controlled by a wall switch.
•Turn off the TV and/or device(s) before you connect or disconnect any cables.
•Make sure all antennas and cables are properly grounded. Refer to the Important Safety Instructions at the beginning of the User's Guide.
Protect Devices from Overheating
•Don’t block ventilation holes on any of the devices. Arrange the devices so that air can circulate freely.
•Don’t stack devices.
•If you place devices in a stand, make sure you allow adequate ventilation.
•If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won’t flow around other devices.
Position Cables Properly to Avoid Audio Interference
•Insert each cable firmly into the designated jack.
•If you place devices above the TV, route all cables down the side of the back of the TV instead of straight down the middle.
•If your antenna uses
Use Indirect Light
Don’t place the TV where sunlight or room lighting will be directed toward the screen. Use soft or indirect lighting.
Remote Control
You will need a master remote or USB Cloner to set up the TV. Contact your RCA Commercial Distributor to purchase these.
Check Supplied Parts
Check that the following parts were packed with your product.
| Optional |
|
| Optional |
|
Model No. : CPS1000 | Model No. : BRK1000 | ||||
Owner’s Manual |
| Power Unit |
| Power Cord |
| DVD Bracket |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Note
-If you need to replace your remote, call
-DVD Bracket is supported in
-DVD Bracket (BRK1000) can support to hold on itself under the weight of 1Kg products likes slim DVD player.
-Power Unit (CPS1000) needs a minimum RF level of +20dBmV for a healthy RF signal level at TV (J12H770).
Chapter 1 | Graphics contained within this publication are for representation only. | 7 |