Other Information
TV turns on unexpectedly
•Wake up timer might have been activated. Go to page 34 for instructions.
•Auto on might have been activated. Go to page 34 for instructions.
•You might have pressed CH+, CH- or INPUT on the remote accidentally.
Blank screen
•Make sure the component connected to the TV is turned on.
•Try another channel.
No sound, picture okay
•Maybe the sound is muted. Try pressing the volume up button to restore sound.
•If using
•Make sure the INT/EXT switch on the back of the TV is put on “INT”.
•The sound settings may not be set correctly. Go to page 33 for more information.
Can’t select certain channel
•Channel may be blocked or not approved in the Parental Controls menu.
•If using a VCR, check to make sure the TV/VCR button on the VCR is in the correct mode (press the TV/VCR button on your VCR).
Noisy stereo reception
•May be a weak station. Use Sound menu to choose mono sound.
No picture/blue screen, no sound but TV is on
•Maybe the cable/air function is set to the wrong position. Go to page 35 for detailed instructions.
•The channel might be blank — change channels.
•If you’re watching your VCR and it’s connected with coaxial cable to the CABLE/ANTENNA jack, tune the TV to channel 3 or 4 (whichever channel is selected on the 3/4 switch on the back of your VCR). Also check to make sure the TV/VCR button on the VCR is in the correct mode (press the TV/VCR button on your VCR).
Sound okay, picture poor
•Check antenna connections. Make sure all of the cables are firmly connected to the jacks.
•Try adjusting sharpness function to improve weak signals. Go to page 34 for more instructions.
Volume buttons not adjusting volume louder
•Check to make sure volume isn’t limited by the maximum volume feature. Go to page 35 for more instructions.
Picture not moving
•You have activated the Freeze feature by pressing OK on the remote. Press any button to “unfreeze” the picture.
Black box appears on the screen
•
Freeze not working
•The freeze feature is not available for Component video (CMP1 or CMP2) or DVI inputs.
Low battery warning appears on screen
•Place new batteries in remote.
42 | Graphics contained within this publication are for representation only. | Chapter 8 |