Panasonic TC-17LA1H, TC-20LA1H, TX-17LA1Z, TX-20LA1Z manual CH Select = Position, CH Select = Direct

Basic controls

Power (Stand-by)

The TV set must first be plugged into the wall outlet and turned on at the TV ON / Stand-by button on the top panel.

Press this button to turn the TV set On from Standby mode, press it again to turn the TV set OFF to Standby mode.

Note:

It is also possible to turn the TV set on from STANDBY mode by pressing the “Direct Programme Number Selection” Buttons (0-9) and the “Programme Number Up or Down” Button, either on the top panel or on the Remote Control.

				Sound Mute
				Press to mute the sound completely the “ ” symbol will appear.
				Press again to restore the previous sound level, and cancel the mute.
PICTURE				Programme Number Selection
				Press to select the next higher or lower Programme number.
SOUND				Volume Adjustment
				Press to increase or decrease		TV/AV Mode Selection
SET UP				the sound volume level.		Press to select TV, AV input
				VOLUME	24	signal modes sequentially.
			TV/AV
						Remote control :
								TV/AV
				Coloured buttons used for		AV1	AV2
TV/TEXT				Teletext functions		Press to display AV1 - AV2 at
	F.P.	INDEX	HOLD	(see page 22, 23, 24)
						the bottom of the screen. Each
				AV Selection
						coloured button corresponds
	1	2	3	TEXT hold (see page 23)		to each input signals. For
						example, pressing the Red
SURROUND	4	5	6	TEXT Index (see page 23)		button selects AV1.
ASPECT	7	8	9		Direct Programme Number
					• Direct Programme Number Selection
					(CH SELECT = POSITION)
		0			You can select the numbers directly by
					pressing “Number 0-9” button and the two
					digit Numbers by pressing “Two Digit” and
					“Programme Number” buttons.

		Programme Number 8	8
	VCR / DVD Operation	Programme Number 12	, 1 , 2
DVD
	(see page 24)
REC-VCR		• Direct Programme Number Selection
		(CH SELECT = DIRECT;
N		except TX-17LA1Q, TX-20LA1Q)

STR

You can select the number directly by pressing the corresponding programme number button.

Channel Number 8	8
Channel Number 36	3	,	6
Channel Number 124...	1	,	2 , 4

Note:

When the Skip setting for Programme Number 100 through 125 is on, the channel selection time will be shortened, and thus you can not input three digits at a time.

11