Power ON / OFF
Turning the Power ON and OFF
Always be sure to follow the procedure given below to turn the Projection Display power ON and OFF.
•The lamp cooling fan will continue to operate for approximately 3 minutes after the power is turned off. During this time, the POWER indicator will blink Red.
Do not disconnect the power cord from the outlet and do not open the circuit breaker (unless necessary) while the cooling fan is still operating. Do not disconnect the power cord from the power outlet while the power indicator blinks Red.
POWER button |
POWER indicator |
The Power Indicator
LED | ACTION |
Off | Power – OFF |
Red (blinking) | Power – OFF (Now cooling) |
Green | Power – ON |
Green (blinking) | Power – ON (Preparing to light lamp) |
Notes
•If the POWER button is accidentally turned off during use, after power is turned back on, it may take a short period before the lamp automatically comes on.
•This unit consumes approx. 0.4 W in OFF condition when plugged into an AC outlet.
Power ON
Press POWER on Projection Display or Remote Control to turn power on.
•The Power Indicator blinks Green for about 10 seconds and then turns solid Green.
•Picture display may be delayed when the unit has not been used for a long time or ambient temperature is low.
•The fan rotating sound may be increased in high temperature condition.
Power OFF
Press POWER on Projection Display or Remote Control to turn power off.
•Power shuts off after a Black Screen is displayed for about
3 minutes. If the POWER button is pressed during the Black Screen display, Power is turned back on.
•The Power Indicator blinks Red for about 3 minutes and then LED turns off.
Auto shut off
•If “No signal
•If “No action
24