Viewing 3D images on TV
You can enjoy 3D images by wearing the 3D Eyewear supplied with this TV and to view 3D broadcasts and 3D image software.
Basic features of 3D Eyewear
This product cannot be used as sunglasses.
This product can be worn over vision correction glasses.
Optional Accessory
Visit http://www.panasonic.com/ for more information.
Part names and functions
Infra-red receiver
Receives infra-red signals from the television.
The liquid crystal shutter open/close timing is controlled by receiving
Accessories
3D Eyewear (1)
3D Eyewear case (1)
Battery case | Nose pad installation section |
Fitting the batteries (p. 23) 3D Eyewear inner section (p. 23) | |
When using for the first time, |
|
remove the insulating sheet. | Specialized band can be |
(p. 23) | attached here. (p. 23) |
Specialized band (1)
If the end of the specialized band is loosened, make a loop at the end as shown in the above figure and smooth the twisted rubber before using.
Nose pad (1 of each)
Liquid Crystal Shutter
Controls the images for 3D viewing.
The left and right liquid crystal shutters are alternately opened and closed in time with the left side and right side images that are alternately displayed on the television to achieve the 3D effect.
Power button
(bottom side of 3D Eyewear)
Switches on the 3D Eyewear power.
Power button
Indicator lamp
Press and hold the power button for approximately 1 second to switch the power on, and the Indicator lamp lights for approximately 2 seconds. To switch the power off, press and hold the power button for approximately 1 second. (The Indicator lamp flashes 3 times, then the power switches off.)
A B
Use either nose pad A or B for your preference.
If you put the 3D Eyewear on vision correction glasses, the nose pad
is recommended to be removed.
Specifications
Lens type | Liquid Crystal Shutter type |
|
| Width: 6.97” (177 mm) |
|
|
| Dimensions | Height: 1.82” (46 mm) |
Batteries |
| |||
|
| Overall length: 6.86” (174 mm) | ||
(duration) | (approx. 75 hours in continuous use) |
|
| |
|
|
| ||
Usage temperature | 32 °F – 104 °F |
| Power supply | DC 3 V |
|
|
| ||
range | (0 °C – 40 °C) |
| Mass (including batteries) | 0.14 lb (63 g) |
|
|
| ||
|
|
|
|
|
| Transmitter for 3D Eyewear |
|
| Main body: resin |
Viewing range* | Within 3.2m from front surface |
| Materials | |
| Lens section: Liquid crystal glass | |||
| (Within ±35° horizontal, ±20° vertical) |
|
| |
|
|
|
| |
|
| * Viewing range: The location of the 3D Eyewear transmitter (p.13) |
22