Panasonic DMR-EH60 Television operation, Test by turning on the television and changing channels

Television operation

You can configure the remote control TV operation buttons to turn the television on/off, change the television input mode, select the television channel and change the television volume.

1 Point the remote control at the television

While pressing [Í POWER TV] enter the code with the numbered buttons.

e.g., 01: [0] ➡ [1]		10: [1] ➡ [0]
Manufacturer and Code No.
			PHILIPS (RC-5)	03
Panasonic
National	01/02		RCA	05
QUASAR
			SAMSUNG	14/18/19
FISHER	10		SANYO	10
GE	05		SHARP	06/07
GOLDSTAR	15/16/17		SONY	08
HITACHI	12		SYLVANIA	03
JVC	11		THOMSON	05
LG	15/16/17		TOSHIBA	09
MAGNAVOX	03		ZENITH	04
MITSUBISHI	13

2 Test by turning on the television and changing channels.

≥Repeat the procedure until you find the code that allows correct operation.

≥If your television brand is not listed or if the code listed for your television does not allow control of your television, this remote control is not compatible with your television.

[Note]

≥If your television brand has more than one code listed, select the one that allows correct operation.

When other Panasonic products respond to this remote control

Change the remote control code on the main unit and the remote control (the two must match) if you place other Panasonic products close together.

Use “1”, the factory set code, under normal circumstances.				started
1	Press [SETUP].
				Getting
2	Press [3, 4] to select “Setup” and
3	press [1].
	Press [3, 4] to select “Remote
4	Control Code” and press [ENTER].
	Press [3, 4] to select the code (1, 2,
	or 3) and press [ENTER].
		SETUP	Remote Control Code
			Press “±” and “ENTER” together
		Channel	for more than 2 seconds on the remote.
		Setup
5		Disc
	To change the code on the remote control
	While pressing [ENTER], press and
	hold the numbered button ([1], [2] or
6	[3]) for more than 2 seconds.
	Press [ENTER].

∫When the following indicator appears on the unit’s display and you are unable to operate the unit

The unit’s remote control code

Change the code on the remote control to match the main unit’s (➡ step 5).

To return to the previous screen

Press [RETURN].

To exit the screen

Press [SETUP].

Power saving function

∫Off Timer

The unit switches to standby after about 6 hours in the stop mode. You can turn this feature off or change the time to 2 hours (➡ 54, “Off Timer”).

RQT8307

19