Panasonic TH-42PHW6, TH-50PHW6 manual Accessories Supply, Remote Control Batteries

Accessories

Accessories Supply

Check that you have the accessories and items shown

Operating Instruction book

AC cord

Remote Control

Transmitter

EUR646530

		INPUT
	SURROUND
	VOL
N		R
PICTURE	SOUND	SET UP
MULTI	SWAP SELECT	MOVE
PIP
PICTURE
POS. /SIZE		ASPECT
PC	OFF TIMER

PLASMA DISPLAY

Batteries for the Remote Control Transmitter

(2 ⋅ R6 Size)

Ferrite core (small size) ⋅ 1

Fixing bands

Ferrite core (large size) ⋅ 2

TH-50PHW6HZ TH-42PHW6AZ TH-50PHW6AZ

Remote Control Batteries

Requires two R6 batteries.

1.Turn the transmitter face down. Press and slide off the battery cover.

2.Install the batteries as shown in the battery compartment. (Polarity + or – must match the markings in the compartment.)

3.Replace the cover and slide in reverse until the lock snaps.

Two “R6” size

Helpful Hint:

For frequent remote control users, replace old batteries with

Alkaline batteries for longer life.

Precaution on battery use

Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.

Observe the following precaution:

1.Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.

2.Do not combine a used battery with a new one.

3.Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).

4.Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.

5.Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display set.

5