Panasonic TH-42PW5 manual Connections, Speakers, Terminals R Terminals L AC cord connection see

Page 9

Connections

When connecting the speakers, be sure to use only the optional accessory speakers. Refer to the speaker’s Installation Manual for details on speaker installation.

Speakers (Optional accessories)

SPEAKERS	SPEAKERS
Terminals (R)	Terminals (L)

AC cord connection (see page 14)

–Cable fixing bands

Secure any excess cables with bands as required.

Pass the attached cable fixing band through the clip as shown in the figure.

To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure.

While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band.

To tighten:

Pull

To loosen:

Push the catch

Pull

		AUDIO
PC	IN	SERIAL

From EXIT monitor terminal on Computer (see page 10)

From SERIAL Terminal on Computer (see page 12)

Image 9

Contents Operating Instructions TH-37PW5 Progressive Wide Plasma DisplayEnglish Dear Panasonic Customer Table of Contents Important Safety Notice For Your SAFETY, Please Read the Following Text CarefullyThis Apparatus Must be Earthed Important Safety Notice SetupWhen using the Plasma Display Cleaning and maintenance If problems occur during useElectric shocks can result if this is not done Accessories Supply AccessoriesOptional Accessories Check that you have the accessories and items shownPrecaution on battery use Remote Control BatteriesObserve the following precaution Helpful HintSpeakers ConnectionsTerminals R Terminals L AC cord connection see Cable fixing bandsInstalling the ferrite core Large size Installing the ferrite core Small sizePC Input Terminals connection ConnectionsSignal Names for D-sub 15P Connector GND Ground Signal NameSDA HD/SYNC SCL Serial Terminals connection CommandCommunication parameters Basic format for control dataBasic Controls Power On/Off Power On/Off and input signal selectionConnecting the AC cord plug to the Plasma Display Connecting the plug to the Wall OutletPower On/Off and input signal selection Select the input signalSelecting the On-Screen Menu Language AV RGB PCOn-Screen Menu Display from Remote Control See page 32 Component see To Signal screen for PC see On-Screen Menu Display from Remote ControlTo setup Screensaver see To setup Multidisplay screen seeAspect Controls Aspect mode changes each time the Aspect buttonZoom Aspect ControlsJust PanasonicAdjusting screen Adjusting Picture Pos./SizeSize/Clock Phase Press to exit from adjust modeSize Clock Phase RGB/PC in Mode Adjusting Picture Pos./SizeHelpful Hint N / Normalise Normalisation PosMute Sound AdjustmentBass TrebleSurround Controls On OffSurround Surround Button Normal Picture AdjustmentsDynamic CinemaPicture Adjustments Advanced SettingsPresent Time Set Set up TimerSetup Timer Timer SetScreensaver For preventing after-images Mode selectionReversal / Scroll selection To stop the Screensaver under On, press the buttonSetup of Screensaver Time Side Panel AdjustmentScreensaver For preventing after-images How to Setup Multi Display Setup for Multi DisplayPress to display the Setup menu screen Multi Display Setup Press to selectPress to select 2 ⋅ 2, 3 ⋅ Setup for Multi DisplayComponent/RGB-in Select Setup for Input Signals3D Y/C Filter For Ntsc AV images ComponentColour system / Panasonic Auto Setup for Input SignalsPulldown If the picture image becomes unstableSetting RGB sync signal Setup for input signals SyncSetting PC sync signal Freq. kHz/V-Freq. HzPlasma Display panel Symptoms Check TroubleshootingConnection to the Optional Terminal Board SpeakerTerminals R Connect the signal source equipment AV Input Terminals connectionVideo 4 pin socket Component signals Y, PB, PR connection Example When connecting 21 pin scart cablesComponent/RGB Input connection RGB signal R, G, B, HD, VD connection Dedicated Receiver connection AV/Component /RGB/ PC input signals Input signal can be displayedAV input Component/RGB input PC RGB input PAL60Specifications Dimensions SpecificationsMass Weight TH-37PW5 TH-42PW5 Optional SuppliedCustomer’ Record

Connections

SPEAKERS

Terminals (R)

Terminals (L)

AC cord connection (see page 14)

–Cable fixing bands