Antenna connection
For proper reception of VHF / UHF channels, an external antenna is required. For best reception, an outdoor antenna is recommended.
VHF Aerial UHF Aerial
VCR
Mixer
ANT OUTPUT | ANT INPUT |
OR
75 Ω Coaxial cable
Notes:
•Do not put the Coaxial cable close to the mains lead to avoid noise.
•Do not place the Coaxial cable under the TV.
•Additional equipment, cables and adapter plugs shown are not supplied with this TV set.
•To obtain optimum quality picture and sound, an Aerial, the correct cable (75 Ω coaxial) and the correct terminating plug are required.
•If a communal Aerial system is used, you may require the correct connection cable and plug between the wall Aerial socket and your TV.
•Your local Television Service Centre or Dealer may be able to assist you in obtaining the correct Aerial system for your particular area and the accessories required.
•Any matters regarding Aerial installation, upgrading of existing systems or accessories required, and the costs incurred, are the responsibility of you, the Customer.
Power On / Off
Connect the mains plug to the wall socket.
Press the [
] switch on the TV set to turn the set on.
Owner ID setting screen is displayed. See page 20.
To switch the TV set to Standby mode, press the 
button on the remote control.
The TV set can be switched on by pressing the 
button again if it was in Standby mode.
Note:
This TV will still consume some power as long as the mains plug is still inserted into the wall socket.
|
| OK |
|
| 1 | 2 | 3 |
| 4 | 5 | 6 |
| 7 | 8 | 9 |
|
| 0 |
|
|
| TV |
|
Remote control signal sensor | |||
Power Indicator |
|
| |
Standby | : Red |
|
|
On | : No Light |
|
|
8