Panasonic BT-LT1700 manual System Config

Main Menu (continued)

g WB adjustment mode

You can adjust “WHITE BALANCE VAR1” – “WHITE BALANCE VAR3” (WB) by selecting “VAR1” – “VAR3” in “COLOR TEMP.” in the “VIDEO CONFIG” menu.

The underlined values are factory preset setting values.

Sub menu	Settings	Explanation
COLOR TEMP.	<USER0–63>	Used to select the color temperature that will become the
	<D93>	basis for adjustments.
	<D65>	<USER0–63>		Adjustable settings 0–63 (color
	<D56>			temperature around 3000K–9300K)
		<D93>	Color temperature around 9300K
		<D65>	Color temperature around 6500K
		<D56>	Color temperature around 5600K
WB-HIGH RED	<0–60>	Used to adjust the WB in the HIGH level R component.*1
	(Factory preset settings: 30)
WB-HIGH GREEN		Used to adjust the WB in the HIGH level G component.*1
WB-HIGH BLUE		Used to adjust the WB in the HIGH level B component.*1
WB-LOW RED		Used to adjust the WB in the LOW level R component.*1
WB-LOW GREEN		Used to adjust the WB in the LOW level G component.*1
WB-LOW BLUE		Used to adjust the WB in the LOW level B component.*1
RESET		This returns the “WB-HIGH RED” – ”WB-LOW BLUE”
		settings to the factory presets.

*1 When adjusting, the item display moves to the lower part of the screen.

SYSTEM CONFIG

		The underlined values are factory preset setting values.
Sub menu	Settings	Explanation
BACKLIGHT	< 0–60 >	Used to adjust the brightness of the liquid crystal backlight.
FUNCTION1	<HV DELAY>	Used to select the functions assigned to [FUNCTION1] and
	<AUTOSETUP>	[FUNCTION2] (front buttons).
	<BLUE ONLY>	<HV DELAY>*2
	<GAMMA	Displays the synchronizing signal (horizontal, vertical).
	SELECT>
		The display is switched in the following order.
	<SD ASPECT>
		OFF J H-Delay J V-Delay J HV-Delay J OFF
	<SCAN>
		<AUTOSETUP>*5
	<SUB
	WINDOW>	Used to automatically adjust the PC display.
	<UNDEF>	<BLUE ONLY>
		Used to cut the red and green signals. You can check the hue (PHASE)
FUNCTION2	<HV DELAY>
		and depth of color (CHROMA). This is switched between ON/OFF by
	<AUTOSETUP>
		pushing the button.
	<BLUE ONLY>
	<GAMMA	<GAMMA SELECT>
	SELECT>	You can switch between “NORMAL” and “FILM”.*3*4
	<SD ASPECT>	<SD ASPECT>
	<SCAN>	Used to switch between “16:9” and “4:3”.*3*4
	<SUB	<SCAN>
	WINDOW>
		You can switch between “UNDER” and “NORMAL”.*3*4
	<UNDEF>
		<SUB WINDOW>
		You can perform the settings for 2 screen display mode.*3*4*6
		<UNDEF>
		No settings

*2 This function is disabled while in 2 screen display mode.

*3 These functions are disabled when the control settings are in GPI mode.

*4 If these settings are changed, the menu settings will also change.

*5 When “RGB-COMP.” is not selected in “YPBPR/RGB” in the “INPUT SELECT” menu, “NOT RGB-COMP.CH-” is displayed, and this does not operate.

*6 This function will not work when “RGB-COMP.” is selected in “YPBPR/RGB” in the “INPUT SELECT” menu.

17