Wireless Configuration – Bridging Encryption

Select appropriate key

Select appropriate key

 

type/length and value. Must

type/length and value.

 

be the same key as Bridge

Must be the same key as

 

2~n.

Bridge 1.

 

 

 

 

 

 

The above recommended setup requires only Bridge 1 to be set in point-to-multipoint mode. It is possible to set all bridges in point-to-multipoint mode, in which case, each bridge would have to contain the BSSID for each of the other bridges and Spanning Tree Protocol must be enabled.

As stated previously, complete any other setup screens following general instructions in Chapter 3.

Repeater bridge configuration

A repeater setup can be used to extend the wireless signal from one bridge connected to an Ethernet LAN wirelessly so that another bridge can control a wireless LAN at a distance.

Repeater bridging setup guide

Direction

Bridge 1

Bridge 2

Bridge 3

 

 

 

 

Wireless Configuration – General

 

 

 

 

 

 

SSID

default (or set for 802.11b/g

default (or set for

default (or set for

 

WLAN)

802.11b/g WLAN)

802.11b/g WLAN)

 

 

 

 

Channel

11

11

11

 

 

 

 

Wireless Configuration –

Select appropriate key type

Select appropriate key

Select appropriate key

Encryption

and length and enter key

type and length and enter

type and length and

 

value

key value

enter key value

 

 

 

 

Wireless Configuration – Bridging

 

 

 

 

 

 

Channel

4

4

4

 

 

 

 

Tx Power Mode

Auto

Auto

Auto

 

 

 

 

 

 

 

 

49

Page 54
Image 54
LevelOne WAB-1000 manual Repeater bridge configuration, Repeater bridging setup guide