LevelOne WAB-1000 guide

will accommodate legacy systems. The 802.11g improves the wireless power but limits use to those WLANs that have only 802.11g clients. The 802.11 b/g mixed allows you to use both 802.11b and 802.11g clients but limits power to that of the 802.11b band.

You can assign a channel number to the AP (if necessary) and modify the Tx Pwr Mode.

The Channel Number is a means of assigning frequencies to a series of access points, when many are used in the same WLAN, to minimize interference. There are 11 channel numbers that may be assigned. If you assign channel number 1 to the first in a series, then channel 6, then channel 11, and then continue with 1, 6, 11, you will have the optimum frequency spread to decrease “noise.”

If you are using the WAB-1000 as both an AP and bridge, the channel number set for the AP board and the channel number set for the bridge should be sufficiently different to avoid interference. Generally, it has been found that selecting Channel 4 for Bridging and Channel 11 for AP gives a good spread.

19

Image 24

LevelOne WAB-1000 manual

Contents

User Guide Page Table of Contents WPA Encryption Page Basic Features Introduction Wireless Basics Network Configuration Access point configurations802.11b 802.11g Possible AP Topologies Bridging Data Encryption and Security WPA with TKIP/ AES-CCMP AES-ECB and 3DES for Bridging MAC Address Authentication Operator Authentication and ManagementDhcp Server Management Hardware installation Preparation for use Installation Instructions Ensure the cabling is correctly installedMinimum system and component requirements Page Indicator Lights Sealing Antenna ConnectionsLED WAN Preliminary configuration steps Introduction Initial setup using the Local port System Configuration General WAN LAN Wireless Setup Page RTS Dtim Encryption Ssid WPA Encryption Page MAC Address Filtering Bridging and Bridging Encryption Rogue AP Detection Advanced Services Settings Snmp Agent User Management List All Users Monitoring/Reports Add New User System Status Bridging Status Wireless Clients Adjacent AP List Dhcp Client List Web Access Log System Log Network Activity System Administration Firmware UpgradeFactory Default Reboot Remote Logging Utilities Configure the WAB-1000 as a bridge General bridge setupPage Page Set up bridging type Point-to-point bridge configuration Point-to-point bridging setup guide BssidPage Page Point-to-multipoint bridge configuration Point-to-multipoint bridging setup guide Repeater bridge configuration Repeater bridging setup guide Bridging Encryption Manufacturer’s Statement Radio Frequency Interference RequirementsChannel Separation and Wlan Cards 3DES AES Dhcp SnmpTkip WPA