Panasonic PT 61DLX75 manual Remote Control Battery Installation, Reset All Memory Functions

Remote Control Battery Installation

Requires two AA batteries (supplied).

1. While pressing in on the catch, open cover in direction of arrow.

Helpful Hints:

(1)For frequent remote control users, replace old batteries with Alkaline batteries for longer battery life.

(2)Whenever you remove the batteries, you may need to reset the remote control infrared codes. We recommend that you record the code on pages 58-59, prior to setting up the remote.

Getting Started

2. Install the batteries as shown in the battery compartment.

(Polarity + or - must match the markings in the compartment).

Two AA size

3. Press cover in direction of arrow until it snaps shut.

CAUTION

Incorrect battery installation can cause the batteries to leak, leading to personal injury and/or damage to the remote control.

Observe the following precautions:

1.Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.

2.Do not combine a used battery with a new one.

3.Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).

4.Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.

5.Battery replacement is necessary when the remote control acts sporadically or stops operating the Projection Display set.

Emergency Alert System (EAS) Forced Tuning

If a CableCARDTM is installed, the cable MSO (multiple system owner/operator) may provide an Emergency Alert System message. These messages are intended to alert the general public of important local or national emergency situations. In the event of receipt of one of these messages, the Projection Display shall immediately tune to the channel as directed by the EAS message. If the channel has been blocked using the parental control, the parental blocking has priority over the forced tune.

Reset All Memory Functions

Use when moving unit to a new location, or First Time Setup needs to be redone.

Press the VOL- button on the unit and OK button on the Remote control at the same time for more than 3 seconds. When reset is done, power shuts off automatically.

CH

VOL OK VOL

CH

7