PICTURE menu
Settings
Remote control | Control panel |
See “Navigating through the MENU” on page 29. See “Main menu and
PICTURE MODE
Depending on the projection environment, you can use these preset parameter settings to optimise image projection. Press I H to cycle through the options.
NATURAL | Reproduces the original colour | |
of the image | ||
| ||
STANDARD | Setting for a general image | |
DYNAMIC | Bright and sharp setting | |
| Setting for when projecting on | |
BLACKBOARD | a blackboard | |
See “BLACKBOARD” on | ||
| ||
| page 38. | |
|
|
NOTE:
•It may take for a while until the selected mode is stabilised.
CONTRAST
You can adjust the contrast of the projected image. Adjust the BRIGHTNESS in advance if necessary.
LowerHigher
BRIGHTNESS
You can adjust the brightness of the projected image.
DarkerBrighter
COLOUR
You can adjust the colour saturation of the projected image. (Available with signals from
LighterDarker
TINT
You can adjust the skin tone in the projected image. (Available with signals from
More More
reddish greenish
SHARPNESS
You can adjust the sharpness of the projected image.
Less | More |
sharp | sharp |
COLOUR TEMPERATURE
You can adjust the white balance of the projected image.
LOW | More bluish |
STANDARD | Balanced white |
HIGH | More reddish |
DAYLIGHT VIEW
You can keep the projected image bright and vivid even in
AUTO: Automatic adjustment
ON: Active
OFF: Deactive
NOTE:
•Do not cover the ALS (Ambient Luminance Sensor) of the projector. See “ALS (Ambient Luminance Sensor)” on page 14.
•AUTO is not available when INSTALLATION setting in OPTION menu is set to REAR/DESK or REAR/
CEILING.