Basic Operation
Projecting an image
Selecting the input signal
1. Switch on the connected devices.
Press the play button of the required device.
2.Press the INPUT SELECT buttons to select the required input method if needed. See “Switching the input signal” on page 26.
The image will be projected on the screen.
NOTE:
•SIGNAL SEARCH is ON as default and the signal from the connected devices is detected automatically. See “SIGNAL SEARCH” on page 37.
•If no signal is detected, the guide screen for computer connection will be displayed (when “INPUT GUIDE” in the “OPTION” menu is set to “DETAILED”. See “INPUT GUIDE” on page 36.)
•Press the INPUT SELECT button to finish the input signal search.
Positioning the image
Follow the procedure below when you set the projector up first, and when you change the placement after original setup.
1. Adjusting the angle.
Place the projector so that it is vertical to the screen.
Screen
While pressing the Front leg adjuster button, adjust the forward/back angle of tilt of the projector. Adjust so that the projected image is placed at the centre of the screen.
See “Front adjustable legs and throwing angle” on page 17.
2. Press the AUTO SETUP button (when RGB signals are being input).
Settings such as the position of the image will be corrected automatically. See “Setting up the image position automatically” on page 25.
3. Adjusting the size.
Turn the Zoom ring to adjust the size of the projected image.
4. Adjusting the focus.
Turn the Focus ring to adjust the focus of the projected image.
Zoom ring
Focus ring
NOTE:
•Heated air comes out of the Air exhaust port. Be careful of this when adjusting the Font adjustable legs.
•If keystone distortion occurs, see “KEYSTONE” on page 34.
•If you adjust the focus, you may need to adjust the size of the image by moving the Zoom ring again.