Technical Information
Serial terminal
The serial connector which is on the connector panel of the projector conforms to the
Connection
COMPUTER1 | DIN 8 pin (male) |
Serial terminal (female)
Serial adapter
Pin assignments and signal names
|
| Pin No. | Signal name | Contents |
1 | 2 | A B F |
| Connected internally |
|
|
| ||
|
| C | RXD | Received data |
3 | 5 | D | GND | Earth |
|
| E | TXD | Transmitted data |
6 | 8 | G H |
| NC |
|
|
|
Communication settings
Signal level | Character length | 8 bits | |
|
|
|
|
Sync. method | Asynchronous | Stop bit | 1 bit |
|
|
|
|
Baud rate | 9 600 bps | X parameter | None |
|
|
|
|
Parity | None | S parameter | None |
|
|
|
|
Basic format
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| The data streaming from the computer will |
| STX | Command | : |
| Parameter | ETX |
| ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| start with STX, and proceed to Command, |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
| Start |
| byte |
|
|
|
|
|
|
|
| Parameter and end with ETX. You can | |||
|
|
|
| 1 byte |
|
| End | ||||||||
|
| 3 bytes | 1 byte - | ||||||||||||
| (02h) |
|
|
|
| (03h) | add the required parameter. | ||||||||
|
|
|
|
|
|
| 4 bytes | ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
The projector can not receive any command for approximately 10 seconds after the lamp is switched on and for approximately 1 second after the cooling fan stops operating and the projector has returned to standby mode (approximately 90 seconds after the indicator switches off).
Be sure to wait until the lengths of time mentioned above have passed before sending the command. If sending multiple commands, check that a response has been received from the projector for one command before sending the next command.
When a command which does not require parameters to be sent, the colon (:) is not required.
If an incorrect command is sent from the personal computer, the ER401 command will be sent from the projector to the personal computer.
Appendix