General Operation, Volume, Vcr/Dvd | Panasonic TX-43P800H instruction

General Operation

Power (Stand-by) (see page 6)				Note:
The TV set must first be plugged	into	the	wall	• It is also possible to turn the TV set on from STANDBY
outlet and turned on at the power switch.				mode by pressing the “Direct Programme Number
outlet and turned on at the power switch.				Selection” Buttons (0-9) and the “Programme Number
Press this button to turn the TV	set	On	from	Selection” Buttons (0-9) and the “Programme Number
Press this button to turn the TV	set	On	from	Up or Down” Button, either on the set or on the
Standby mode, press it again to turn the TV set				Up or Down” Button, either on the set or on the
Standby mode, press it again to turn the TV set

OFF to Standby mode.

Remote Control.

Sound Mute

Press to mute the sound completely the “Mute” symbol will appear. Press again to restore the previous sound level, and cancel the mute.

PICTURE

SOUND

SET UP

TV/TEXT

100Hz/

PROGRE

SURROUND

TV/AV

F.P. INDEX HOLD

CH SEARCH STILL

1 2 3

Programme Number Selection

Press to select the next higher or lower Programme number.

Coloured buttons used for Multi Screen functions

(see page 27, 28) Teletext functions (see page 29) AV selection (see page 11)

TEXT Index (see page 31) /Channel Search (see page 28)

TEXT hold (see page 30) /Still (see page 28)

Volume Adjustment

Press to increase or decrease the sound volume level.

VOLUME

TV/AV Mode Selection

Press to select TV, AV1, AV2, AV3 and AV4 input signal modes sequentially.

Remote control :

TV/AV

AV1 AV2 AV3 AV4

Press to display AV1 - AV4 at the bottom of the screen. Each coloured button corresponds to each input signals. For example, pressing the Red button selects AV1.

4 5 6

MULTI

PIP

7 8 9

VCR/DVD Play

VCR/DVD

Fast Forward/cue

VCR/DVD Stop

DVD

REC-VCR

	N	VCR/DVD Control
	N	(see page 32)
	STR HELP	(see page 32)
	STR HELP
	?
		Help (see page 12)

Direct programme Number

•Direct Programme Number Selection

(CH SELECT = DIRECT)

You can select the number directly by pressing the corresponding programme number buttons.

Programme Number 8
Programme Number 36	8 ,

Programme Number 124... 3 , 6 ,

1 2 4

•Direct Programme Number Selection

(CH SELECT = POSITION) (Other than Australia)

You can select the numbers directly by pressing “Number 0-9” buttons or by pressing “Two Digit” and “Number 0-9” buttons.

Programme Number 8	8
Programme Number 12....	, 1 , 2

Note:

•When the Skip setting for Programme Number 100 through 125 is on, the channel selection time will be shortened, and thus you can not input three digits at a time.