Panasonic TH-37PH10UK manual Connections, Speakers, AC cord fixing

Unplug the AC cord pressing the two knobs.

Connections

When connecting the speakers, be sure to use only the optional accessory speakers. Refer to the speaker’s Installation Manual for details on speaker installation. (Example: TH-42PH10UK)

Speakers (Optional accessories)

SPEAKERS

Terminals (L)

SPEAKERS	AC cord connection (see page 13)
Terminals (R)
	– AC cord fixing

1
2	1
	2

Plug the AC cord into the display unit. Plug the AC cord until it clicks.

Note:

Make sure that the AC cord is locked on both the left and right sides.

–Cable fixing bands

Secure any excess cables with bands as required.

Unplug the AC cord

Note:

When disconnecting the AC cord, be absolutely sure to disconnect the AC cord plug at the socket outlet first.

Pass the attached cable fixing band through the clip as shown in the figure.

1

To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure.

While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band.

To tighten:	To loosen:
	Push the catch
Pull
2	Pull

R AUDIO	L	S VIDEO R	AUDIO	L	VIDEO	R AUDIO L	PR/CR/R PB/CB/B	Y/G			AUDIO
B		AV IN		A		COMPONENT/RGB IN
SLOT1		SLOT2					SLOT3		PC	IN	SERIAL

	Optional Terminal	Dual Video Terminals	COMPONENT/RGB IN and
	Board Insert Slot	(equivalent of BNC	Audio IN Terminals (equivalent
	(covered)	Dual Video Terminal	of BNC Component Video
		Board (TY-FB9BD))	Terminal Board (TY-42TM6A))
Notes:		(see page 12)	(see page 12)

•At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.

•TH-37PH10UK has two slots only.

From EXTERNAL monitor terminal on Computer (see page 10)

From SERIAL Terminal on Computer (see page 11)

9