Panasonic MN103S manual Microcomputer Basics

2.6.3	Serial interface UART transmission interrupt	48
2.6.4	A/D conversion interrupt	50
2.6.5	Enable multiple interrupts	52
2.7	Main routine	54
2.7.1	A/D conversion processing	55
2.7.2	Serial reception data processing	57
2.7.3	Key input processing	60
2.7.4	PWM output setting	62
2.7.5	Switching PWM output phase	68
2.8	Watchdog timer settings	71
2.8.1	Reset watchdog timer	71
2.8.2	Watchdog timer overflow processing	74
2.9	Creating executable EX files	75
2.9.1	Introduction of BAT files	75
2.10	System for developing this program	76
2.10.1	Development system configuration	76
Chapter 3 Microcomputer Basics 1
3.1	Chapter overview	2
3.2	External interrupt	3
3.2.1	Setting specification polarity edge interrupts	3
3.2.2	Setting both edges interrupts	8
3.2.3	Specification polarity edge interrupt using noise filter	13
3.2.4	Both edges interrupts using noise filter	20
3.3	I/O ports	27
3.3.1	Setting output port	27
3.3.2	Setting input port	30
3.4	Input-only port	33
3.4.1	Setting input-only port	33
3.5	Pull-up resistor	35
3.5.1	Setting pull-up resistor	35
3.6	8-bit timer operation	37

Table of Contents 2