Installation
External Equipment Connections
VCR Setup
-To avoid picture noise (interference), leave an adequate distance between the VCR and TV.
-Typically a frozen still picture from a VCR. If the 4:3 picture format is used; the fixed images on the sides of the screen may remain visible on the screen.
When connecting with an antenna cable
TV Back panel
1
2
ANT IN
ANT OUT
OUT
(R) AUDIO (L) VIDEO
IN
VCR
1Connect the RF antenna out socket of the VCR to the Antenna socket on the set.
2Connect the antenna cable to the RF antenna in socket of the VCR.
3Set VCR output switch to 3 or 4 and then tune TV to the same channel number.
4Insert a video tape into the VCR and press PLAY on the VCR. (Refer to the VCR owner’s manual.)
When connecting with a RCA cable
1 Connect the AUDIO/VIDEO jacks between TV
TV Back paneland VCR. Match the jack colors (Video = yellow, Audio Left = white, and Audio Right = red)
2 Insert a video tape into the VCR and press PLAY on the VCR. (Refer to the VCR owner’s manual.)
3 Select Video input source with using the TV/AV button on the remote control.
1
• If you have a mono VCR, connect the audio cable from the VCR to the AUDIO L/MONO jack of the set.
ANT IN
ANT OUT
OUT
(R)AUDIO (L) VIDEO IN 
VCR
15