Troubleshooting
WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or Magnavox for help.
E n g l i s h
Problem
Disc cannot play
No sound
No picture, unsteady picture or incorrect picture position
Failure in playing a disc continuously or repeated playback of a disc
Remote control does not work
Solution
✔Make sure a disc is loaded.
✔Make sure a disc is loaded with the label side up.
✔Disc dirty or damaged. Clean the disc.
✔Make sure the region code of the player is the same as that of the DVD disc loaded.
✔Moisture has condensed in the player. Remove the disc and leave the player
✔Check whether the set is connected securely.
✔Make sure the set is not in the MUTE mode. If it is, press MUTE to turn on the speaker.
✔Check whether the volume on the set has been set to the lowest level. If it has, turn up the volume.
✔Disc dirty/damaged. Clean or replace the disc.
✔Make sure the video type of the AV signal source is NTSC.
✔Check whether the set is connected securely.
✔Disc dirty/damaged. Clean or replace the disc.
✔Make sure the player is not in the
✔Disc dirty/damaged. Clean or replace the disc.
✔Remove obstacles between the remote control and the player, and point directly instead of at a wide angle at the infrared sensor on the player.
✔Make sure the battery has been inserted properly (check polarity).
✔Battery maybe exhausted. Replace the battery with a new one.
27