Memorex MVUC821 manual FM Antenna, Outdoor VHF/UHF Antenna Connection Antenna not Included

AM ANTENNA:
Connect the black AM Loop Antenna wire to the black AM Antenna terminal and the white AM Loop Antenna wire to the white
AM Antenna terminal.	2	3	1
1

Extend the AM Loop Antenna	Connect	the	AM Loop	At the bottom of the AM				Insert the tabs into the gaps in
wire.	Antenna’s black wire to the			Loop	Antenna,	rotate	the	the stand. Remember to fully
	black terminal and the white			sta n d	to th e	re a r	a n d	extend the AM Loop Antenna
	wire to the white terminal at the			then push the stand to				wire and locate it away from the
	rear of the main unit. Make sure			the front .				main unit, AC adaptor and other
	the wires are inserted correctly							equipment for better reception
	into the terminals as shown.							and to prevent interference.

FM ANTENNA:

For best FM reception, extend the FM Wire Antenna to its full length

NOTES:

• To improve the AM signal, move the AM Loop Antenna away from the system, AC Adaptor and other equipment.

• To improve FM signal, extend FM antenna fully and keep the FM antenna as horizontal as possible after connection.

OUTDOOR VHF/UHF ANTENNA CONNECTION (ANTENNA NOT INCLUDED)
Follow the instructions for the type of antenna system you intend to use.
Combination VHF/UHF	Combination VHF/UHF	Separate VHF/UHF Antennas
Antenna (Single 75 ohm cable	Antenna (Separate VHF and
or 300 ohm twin-lead wire)	UHF 300 ohm twin-leads)

Connect the 75 ohm cable from combination VHF/UHF antenna to the antenna jack. OR

If your combination antenna has a 300 ohm twin-lead wire, use a 300-75 ohm matching transformer (NOT SUPPLIED).

Connect the UHF twin-lead wire to a combiner (NOT SUPPLIED). Connect the VHF twin-lead to a 300-75 ohm matching transformer (NOT SUPPLIED). Attach the transformer to the combiner. Attach the combiner to the antenna jack.

11

Connect the 75 ohm cable from the VHF antenna and the UHF antenna twin-lead wire to a combiner (NOT SUPPLIED). Attach the combiner to the antenna jack. NOTE: If your VHF antenna has a twin- lead wire, use a 300-75 ohm matching transformer, then connect the transformer to the combiner.