Kenwood RC-R0507 instruction manual Case of difficulty, Remote control unit, RC3, RC5, RC6

In case of difficulty

			RC-R0507 (En/T)
Remote control unit				13
Symptom	Cause	Remedy
The backlight flashes five times during nor-	• The batteries are nearing exhaustion.	• Replace with new batteries to preserve the
mal operation.		currently registered setup information.
Subwoofer volume cannot be adjusted.	• Subwoofer is OFF.	• Turn the subwoofer ON.
Certain inputs cannot be selected using the	• No Setup codes registered at for the respec-	• Register a Setup code or Non-IR code at the
remote control.	tive input(s).	respective input(s).	RC3
Remote control operation is not possible.	• The remote control is set to a different opera-	• Press VIDEO, AUDIO, or TV to select the
	tion mode.	approriate operation mode.
	• Batteries are exhausted.	• Replace with new batteries.
	• The remote control unit is too far away from the	• Operate the remote control unit within the
	main system, controlling angle is too large, or	controllable range.
	there is an obstacle between the receiver and
	the remote.
	• The audio cords and system control cords are	• Connect properly referring to “Setting up the
	not connected properly.	system”.
	• No software is loaded in the source compo-	• Place software in the source component you
	nent.	want to play.
	• An attempt is made to play a tape which is	• Wait until recording has completed.
	being recorded in the cassette deck.
	• The remote control has not been set to the	• Press the VIDEO, AUDIO, or TV key to activate
	operation mode for the component you wish to	the operation mode for the component you
	control.	want to control before operation.	RC5
	• The microprocessor of the remote control	• Reset the microprocessor.	RC6
	malfunctions.
The “MONITOR” indicator appears when	• VIDEO2/MONITOR is set to “MONITOR”.	• When the “MONITOR” indicator is displayed,
pressing the VIDEO key.		delete the preset code.	RC6

Remote Control