Quick Start Guide, Automatic input naming

Quick Start Guide

RC-R0507 (En/T)

Step 1

Look up the setup code for the component you want

to control.

RC7

Write down all the applicable setup codes. (This step is very important.)

Step 2

Step 5

POWER

Press the POWER key to see if you can turn the component on and off. (If the component you want to control has a mechanical power key that cannot be operated by remote control, press the PLAY key or the TUNING/SKIP key to test it.)

Hold down ENT key until the back-

ENTlight flashes twice (about three seconds).

If the component does not respond when you try to control it, return to step 4 and enter the next setup code on the list. Repeat this procedure until you find the code that matches the component.

Step 6

For step 2 through step 8, make sure you start the next step within five seconds of completing the previous one. If more than five seconds elapses between any two steps, you will need to go back and start over from step 2.

ENT

Press the ENT key to store the code.

Step 3

Step 7

Repeat steps 3 though 6 to enter the codes for each component you want to control.

	AUDIO		Press the VIDEO, AUDIO, or TV
VIDEO		TV	key to select the input you want to
			key to select the input you want to
			register. (Each press of the key
			register. (Each press of the key
			advances you one by one through
			the available input settings.) The
			current input setting appears on
			the display of the receiver.

Step 4

Step 8

ENT

Once you have finished register- ing setup codes for all of the in- puts, hold down ENT key until the backlight flashes twice (about three seconds).

This exists the registration mode.

MENU	THEME	FAV	Use the numeric keys to enter the
MENU	THEME	FAV
1	2	3	4-digit setup code for the compo-
TV/SAT/VID	INFO	ALT AUD	4-digit setup code for the compo-
TV/SAT/VID	INFO	ALT AUD	nent.
4	5	6	nent.
+100	REPEAT	RANDOM

If you accidentally exit the registration mode by pressing the wrong key, you will not lose any setup codes you have already saved.

Remote Control

7 8 9

DISPLAY

Automatic input naming

In the initial factory setting, the remote control already has provisional component names registered for each input. Before you register setup codes, pressing the input keys of the remote control causes the display to change from the factory preset input names of the receiver (VIDEO1, VIDEO2, etc.) to the input names registered in the remote control (VCR1, VCR2, etc.). Once you have registered the appropriate setup codes for your components, pressing the input keys of the remote control causes the display to change to the actually connected component names (LD, DVD, etc.) for which you have registered setup codes.