Orion 10DT instruction manual Aerial CONNECTIONS/POWER Sources, Indoor Aerial, External Aerial

Page 8

AERIAL CONNECTIONS/POWER SOURCES

Connect an indoor or outdoor aerial to the aerial socket at the rear panel as shown below. For all aerial circuit problems, please consult your local dealer.

(A) INDOOR AERIAL

(B)

(A)

If an external aerial is not available, the telescopic aerial (supplied) may be used in areas of good TV reception. Adjust position for best reception.

(B) EXTERNAL AERIAL

The type of aerial required depends on the position of your home, its distance from the transmitter and local interference. If you do not have an aerial and you are uncertain of what to buy, you should seek the advice of a local aerial contractor.

OUTPUT SORTIE

DIGITAL

 

RF IN

ON OFF

AUDIO

COAXIAL

 

 

 

MAIN POWER

ANALOGUE

L(G)

 

 

AUDIO

SCART

 

 

 

 

 

R(D)

PRISE PERITEL

 

Aerial socket

TO USE AC POWER

Use the AC line cord provided for operation on AC. Insert the AC cord plug into 240V 50Hz AC outlet.

Press MAIN POWER switch on the back panel, the red standby indicator will light. Turn on your unit by pressing Sub Power () on the front panel or on the remote control, the red standby indicator goes off.

TO USE DC POWER

By using the DC car cord supplied with the unit, you can operate this unit from a cigarette lighter socket in any car that utilizes a negative ground system.

The fused 12V DC car cord has been designed to power the set from the external DC power (12 volt negative ground) through the unit's DC input jack.

Connect the smaller plug on the end of the

CAR

To Cigarette

cord to the DC input jack on the rear of the unit, then insert the other end of the car cord into the cigarette lighter socket of your car. The red standby indicator will light.

It is not necessary to switch the main power switch to ON. Switch on your unit by pressing Sub Power () on the front panel or on the remote control, the red standby indicator goes off.

To DC Input Jack

OUTPUT SORTIE

DIGITAL

 

RF IN

ON OFF

AUDIO

COAXIAL

 

 

 

MAIN POWER

ANALOGUE

L(G)

 

 

AUDIO

SCART

Car Cord

 

 

 

R(D)

PRISE PERITEL

Lighter Socket

WARNING: Never watch the unit while driving the vehicle.

NOTES: • When the unit is not in use, always disconnect it from the car cigarette lighter socket to avoid a battery drain.

Do not operate the unit if the car battery is weak. Peak current from the car alternator could blow the DC fuse.

The unit will still consume Power when in STANDBY mode.

6

Image 8
Contents MODEL10DT Mains Supply Contents FeaturesPrecautions Rear Location of ControlsFront Remote Control Select EnterRemote Control External Aerial Aerial CONNECTIONS/POWER SourcesIndoor Aerial Using an Audio Amplifier Using an AV Amplifier with built-in digital surroundConnection to Other Equipment Rear of unitInput Selection To connect the unit to a VCRFront of unit To connect the TV to a TV GameThen press SELECT/ENTER Language SettingSELECT/ENTER Presetting the Channels Automatic TuningPress SETUP/MENU Press SELECT/ENTERPress or to select the Manual mode, then press Manual TuningHow to tune a station to channel 10 position Example Changing of channel position from CH2 and CH5 Before setting After settingTo Change the Channels Automatic Power Shut Off TV OperationsOn screen display will disappear after 4 seconds Direct Channel Selection buttonsIndicator appears on Screen in AV modeConvenient Functions Or AV2 from Audio/VideoPicture Adjustments To adjust the Brightness Press or , then pressPress SETUP/MENU twice to return to normal TV screen Press or to select the Picture mode, then pressAV Colour Adjusting Reception of Interference IgnitionIgnition Ghosting Ghosting SnowTeletext Basic operationMagnifying How to call a specific sub-pageTo call a teletext Disc Following pages describe the setup/operation in DVD mode PREPARATION/STATUS Display of DiscPreparation Status display of discSetting Language Press SETUP/MENU in the stop modeOther Selection Menu/Audio/Subtitle Off subtitlePlayback Procedure PowerPress OPEN/CLOSE on the unit or the remote con- trol Press OPEN/CLOSE orSpecial Playback ZOOMING/LOCATING Desired Scene ZoomingLocating Desired Scene Press Jump during playAudio CD REPEAT/RANDOM/PROGRAM Playback and Repeat A-BRepeat A-B To Cancel the Mark Press Marker during Playback or stop modeMarking Desired Scenes Marking the ScenesChanging Soundtrack LANGUAGE/SUBTITLES Changing soundtrack languageSubtitles Turning the Subtitles On and OffChanging ANGLES/TITLE SELECTION/DVD Menu Changing AnglesTitle Selection DVD MenuSetting the aspect ratio of TV screen Status on screen displaySelect Enter ReturnDynamic Range Control Press or to select SoundEnter to select DRC Enter to select On or OffParental Control Setting To Change the Parental Level Or SelectTemporary Disabling of Rating Level by DVD Disc Language Code List Before Requesting Service PowerRemote Control TV Broadcast ReceptionSpecification Television03/08 K Power supply system To use a Household Power SupplyTo use DC Power Aerial Connections Connect as followsOn-screen language selection How to install the batteriesUnit turning on Gerät einschalten Channel preset Automatic tuningSetting Setup language for DVD Playback