RU760.qxd
Instructions for use
Setting the remote control
This is only necessary if your appliance does not respond to the RU760.
If that is the case, the RU760 does not recognize the brand and/or model of your appliance and you need to program the remote control to do so.
The example below (TV) instructs you how to do this.
You can repeat the same steps for other appliances (DVD,VCR, etc.) which you want to operate using the RU760.
Example of TV:
1Turn on the TV manually or use the original remote control. Tune in to channel 1.
2Look up the brand of your TV in the code list at the back of this manual. One or more
Be careful! There are separate tables for TV, VCR, DVD, etc. Make sure you use the codes from the correct table.
3Select TV with the mode selector
(See ‘Testing the remote control’.)
VCR DVD SAT AMP CD
LEARN SELECT GUIDE
TITLE | AUDIO CHAPTER SUBTITLE |
4Keep the LEARN key pressed for 5 seconds
until the green light around the Standby key |
|
|
blinks twice and then remains lit. | VCR DVD SAT AMP CD | |
| LEARN | SELECT GUIDE |
| TITLE | AUDIO CHAPTER SUBTITLE |
| DISC | SYSTMENU |
5Enter the code noted in step 2, using the digit keys.
– The green light will now blink twice.
If the light blinks once for an extended period, the code has not been entered properly or the wrong code has been entered.
Start again from step 2.
6Point the RU760 at the TV and check that it responds as it should.
–If the TV responds to all of the key commands, the RU760 is ready for use. Do not forget to note your code.
•If the device does not respond at all, or not to all of the key commands, start again from step 2 and try the next code from the list.
English
5