TV SECTION
TV OPERATION AND SETTINGS
SET UP FOR THE
FIRST TIME
TV
1Plug in the unit power cord
Plug the unit power cord into a standard
AC outlet.
NOTE:
• If some digits appear in the corner of the screen, hit [POWER] without unplugging the power cord.
2Turn on the unit
Hit [POWER] to turn on the unit.
3Select the On Screen Language
Press [K / L] to point to “LAN- | – SET UP – | |
GUAGE”, then hit [ENTER] to | B LANGUAGE | |
select “ENGLISH” or | ||
[ENGLISH] ESP FRA | ||
“ESP”=Spanish or “FRA” =French. | AUTO PRESET | |
“[ ]” indicate the selected language. |
|
4 Begin auto preset |
|
Press [K / L] to point to “AUTO | – SET UP – |
PRESET”, then hit [ENTER]. | LANGUAGE |
The tuner scans and memorizes all | [ENGLISH] ESP FRA |
| |
active channels in your area. | B AUTO PRESET |
NOTES:
•The unit distinguishes between
standard TV channels and cable (CATV) channels.
•The unit may memorize TV channels as CATV channels if reception condition is poor. If this hap- pens, try “AUTO PRESET” action again when reception conditions are better. Refer to “CHAN- NEL RESETTING” on page 16.
5After scanning
The tuner stops on the lowest memorized channel. You can select the desired channel directly with the Number buttons or [CH. K / L].
NOTE:
•Channel memory programming is NOT needed when connected to a cable box or satellite box. Just select the unit channel selector to the output chan- nel of the cable box or satellite box (Ex CH3). Then select the channel to be viewed on the Cable Box or Satellite Box.
WATCHING A TV PROGRAM
TV
1Turn on the unit
Hit [POWER] to turn on the unit.
2Select the channel number
Press [CH. K / L] to select your desired channel number or press the Number buttons.
Note for using the Number buttons:
¡When selecting cable channels which are higher than 99, hit +100 first, then press the last two dig- its. (Example: to select channel 125, first hit [+100] then hit [2] and [5]).
¡You must precede
3Adjust sound
Press [VOL. X / Y] to adjust the volume. Hit [MUTE] to instantly mute the sound.
Hit it again to restore the previous sound level.
NOTE:
•If you press [CH. K / L] in the DVD mode, you can change the TV channels.
Even if you turn off the unit in the
DVD mode, when you turn it on VOLUME 20
C C C C C C C C C C C C C C C C
again, it will go into the TV mode.
TO WATCH CABLE OR SATELLITE CHANNEL
•If the unit is connected to a cable box or satellite box, press [CH. K / L] to select CH3 or CH4 according to the output channel setting of the device, and select desired channel on that device.
TO WATCH EXTERNAL INPUT
•When an external equipment is connected to the front AUDIO/VIDEO input jacks, press [SELECT] or [CH. K / L] repeatedly until “AUX” appears on the screen.
– 14 – | EN |