FUNAI MWC13D5 A SET UP for USE, Selecting the Language, Channel SET UP, Auto Channel Programming

SET UP FOR USE

TV SECTION

SELECTING THE LANGUAGE

TV

1Plug in the unit power cord

Plug the unit power cord into a standard

AC outlet.

NOTE:

• If any digits appear in the corner of the screen, hit [STANDBY-ON]with- out unplugging the power cord.

Make sure ...

•Hit [STANDBY-ON]to turn on the unit.

NOTE:

•This function effects only the language on the screen menu and not the audio source.

2 Select “LANGUAGE”	- TV SETUP -
Hit [SETUP] on the remote control.	CHANNEL SET UP
Press [K / L] to point to “LAN-	V-CHIP SET UP
	CAPTION [OFF]
	B LANGUAGE [ENGLISH]
GUAGE”.

3Select “ENGLISH”, “ESPAÑOL” or “FRANÇAIS”

Select “ENGLISH”, “ESPAÑOL”= Spanish or “FRANÇAIS”= French using [ENTER].

4Exit the Language mode

Hit [SETUP] to return to TV mode.

NOTE: If for some reason the menu is in Spanish or French, press [K / L] to point to “IDIOMA [ESPAÑOL]” or “LANGAGE [FRANÇAIS]”, then hit [ENTER], then hit [SETUP] on the remote con- trol.

CHANNEL SET UP

Make sure ...
	TV
• The unit must be turned on.

AUTO CHANNEL PROGRAMMING

As the initial setting, this unit has memorized all channels, including the ones not available in your area. This feature automatically puts only available channels into the memory.

1 Select “CHANNEL SET UP”

Hit [SETUP] on the remote control.	- TV SETUP -
Press [K / L] to point to “CHAN-	B CHANNEL SET UP
NEL SET UP”.	V-CHIP SET UP
	LANGUAGE [ENGLISH]
	CAPTION [OFF]
Then hit [ENTER].
2 Begin auto ch programming
Press [K / L] to point to “AUTO	– CHANNEL SET UP –
CH PROGRAMMING”.	ADD / DELETE CH (CATV)
Then hit [ENTER].	B AUTO CH PROGRAMMING
The tuner scans and memorizes all
the active channels in your area.

3After scanning

The tuner stops on the lowest memorized channel.

• When AUTO CH PROGRAM-

MING is activated where there is
no TV signal input, “NO TV SIG-	NO TV SIGNALS
NALS” will appear on the display
after the completion of the chan-
nel scanning.

•The unit may recognize CATV channels to be TV channels by the receiving conditions. In this case, try auto ch programming again in the fine receiv- ing conditions.

•Channel memory programming is NOT neces- sary when connected to a cable box or satellite box. Just select the channel for cable or satellite input (Ex CH3) on this unit, then select your desired channel on the cable box or satellite box.

– 13 – EN