FUNAI MWC13D5 A owner manual Mpaa Rating SET UP, Change Access Code

NEW CODE

_ _ _ _

CONFIRM CODE

_ _ _ _

B MPAA RATING SET UP

Follow steps 1 to 3 in the “V-CHIP SET UP” section on page 17.

4Select your desired item

Press [K / L] to point to your		PG	[VIEW]
		G	[VIEW]
desired item, then hit [ENTER] to		PG–13	[VIEW]
		B R	[BLOCK]
select [BLOCK] or [VIEW].		NC–17	[BLOCK]
		X	[BLOCK]
Selection	Rating Category Explanations
G	General Audience
PG	Parental Guidance suggested.
PG-13	Unsuitable for children under 13
R	Restricted; under 17 requires accompa-
	nying parent or adult guardian
NC-17	No one under 17 admitted
X	Mature audience only

•When you select a rating and set it to [BLOCK], the higher ratings will be blocked automatically. The lower ratings will be available for viewing.

•When you set the lowest rating to [VIEW], all other ratings will automatically be available for viewing.

5Exit the V-Chip setting mode

Hit [SETUP] to exit the menu.

C CHANGE ACCESS CODE

Follow steps 1 to 3 in the “V-CHIP SET UP” sec- tion on page 17.

4Enter New code

Press the Number buttons to

enter your desired access code in the “NEW CODE” space, then

enter the same code in the “CON- FIRM CODE” space. When com-

pleted, the menu will return to “V-CHIP SET UP”.

•Make sure you enter exactly the same new code in the “CONFIRM CODE” space as one in the “NEW CODE” space. If they are different, the “NEW CODE” space is cleared for redoing.

5Exit the V-Chip setting mode

Hit [SETUP] to exit the menu.

NOTE:

•Your personal access code will be erased and will return to the default (0000) when a power failure occurs or when you turn off the power using a wall switch. If you have forgotten the code, unplug the power cord for 10 seconds to restore the access code to 0000.

– 18 – EN