FUNAI MGD134 Deleting or Adding Channels, Press Arrow K/L to point to ADD/DELETE CH Press Enter

DELETING (OR ADDING)

CHANNEL(S)

TV

The channels you no longer receive or seldom watch can be deleted from the memory. (Of course, you can add the deleted channel into the memory again.)

1Select “CHANNEL SET UP”

Press SETUP on the remote control. Press Arrow (K/L) to point to “CHANNEL SET UP”.

Then press ENTER.

- TV SETUP -

BCHANNEL SET UP V-CHIP SET UP LANGUAGE [ENGLISH] CAPTION [OFF]

2Select “ADD/DELETE CH”

Press Arrow (K/L) to point to “ADD/DELETE CH”.

Press ENTER.

– CHANNEL SET UP –

BADD / DELETE CH (CATV) AUTO CH PROGRAMMING

3Enter the desired channel number

Press Arrow (K/L) until your desired channel number appears. (You can also use the number but- tons or CHANNEL(CH.) K/L to enter it) (Example: CH8)

08

ADD / DELETE

•

•

You must precede single-digit

channel numbers with a zero (Example: 02 ... 09). When selecting cable channels which are higher than 99, press +100 first, then press the last two digits. (Example: to select channel 125, first press +100, then press 2 and 5).

4Delete (or add) it from (into) memory

Press ENTER. The channel number changes to light red. The channel is deleted from memory.

•To delete another channel, repeat steps [3] and [4].

•If you press ENTER again, the channel is memo- rized again.

Added channel: Light blue.

Deleted channel: Light red.

5Exit the channel setup mode

Press SETUP to return to TV mode.

NOTE: To confirm that channel(s) has been deleted or added, press CHANNEL(CH.) K/L.

– 14 – EN

0C28