Channel setup, Vhf Uhf, Catv | Haier HTN20R16 manual

Channel setup:

By pressing MENU button ,and then pressing VOL-/+ button it will bring you to Channel Setup menu. You will see the following display on TV screen.

Follow the procedure below to select above options:

1.Press the CH(+) and CH(-) button to go up and down the menu. 2.Press VOL (+) button or VOL (-) button to select your preference.

Channel System: Press the VOL(-/+)		buttons to select the correct channel system.
	In general, you can set it as "Auto" Auro,NTSC and NTSC443
	will display in turn
Antenna:	Press VOL (+) button or VOL(-) button to select Aerial Antenna
	(TV) or Cable Antenna (CATV) reception preference.
Skip :	Press VOL(+) button or VOL(-) button to add or delete a channel
	from the stored memory.
Current Ch. :	Press VOL(+) button to go up and VOL (-) button to go down to set
	the channel position. The display will show the current playing
	channel.
	Channel Coverage by Antenna:
	Antenna Type	Channel Range
	VHF	2-13
	UHF	14-69
	CATV	1-125
Fine:	If the picture and/or sound are poor, try using the FINE TUNE
	feature. Do not use this feature unless reception is poor. Press
	VOL (+/-) to start the Fine Tune function.
Auto Program:	Press VOL (+) button to auto program channels. This search

automatically adds only the active channels in your area to the TV's memory. It deletes any channels on which there is no broadcast or a poor signal.

Note: The Auto Search function will scan the channels on the selected antenna

input. If the TV is connected to cable, please select Cable under ' Air Cable ' sub menu.