Philips FW-P73 Setting up the Dolby Pro Logic system, Positioning the Speakers, Test Tone

10 DOLBY PRO LOGIC

Dolby Pro Logic

This state of the art Dolby Pro Logic mini system enables you to experience and enjoy a Home Cinema sound ambience.The Pro Logic system allows more accurate definition of the individual sound sources. It produces greater sound separation between channels and provides pinpoint sound localization. Pro Logic provides four sound outputs: Left, Center, Right and

5-Speaker Connection

•Front speakers: Connect the front speakers.

•Center speaker: Connect the center speaker.

•Rear (surround) speakers: Connect either the wired rear surround speakers or a pair of wireless rear speakers (not supplied) to the SURROUND OUT terminals.

Front Left and Right Speakers

For the best sound, place the Left and Right speakers at an angle of approximately 45 degrees to the listener. If the speakers' magnetic field affects the television picture, increase the distance between the TV and the speakers.

Center Speaker

For the best sound, place the center speaker at the same height as the left

1 Press CD, TUNER, TAPE or AUX

to switch on the system.

2 Press TESTTONE.

ª A test signal is generated; it will move through the Left, Center, Right, and Surround speakers, in that order.

ª "TEST TONE" followed by

"ADAPT BALANCE, CENTER AND REAR LEVEL" will be displayed.

Surround (Rear). Front sounds are produced from the pair of Left and Right speakers and a Center speaker. The surround sound is reproduced by two speakers placed at the rear of the listening area. Although the surround sound is monaural (single-source), a pair of speakers is necessary to produce the correct diffused sound.

CENTER

REAR

SURROUND

REAR

LEFT

REAR

RIGHT

FRONT

FRONT

LEFT

FRONT

RIGHT

and right speakers. Place the center speaker directly above or beneath the television.

Rear (surround) Speakers

The surround speakers should be placed at normal listening ear level or mounted on the wall at the back of the room. Most important, experiment when placing the surround speakers in

ª The test signal will last for about 90 seconds.

3 Press		DPL
BALANCE
	L BALANCE R
L to adjust	CENTER	￿
the sound of		REAR
	- - +	- - +
the front left		REAR
speaker.

ªThe display will show "BAL L+XX".

This Pro Logic decoder enables you to decode the following modes: Dolby

Surround, Center Phantom, Dolby 3 Stereo or normal Stereo.

Setting up the Dolby Pro Logic system

You must set up the system properly in order to enjoy the Home Cinema sound to the fullest. First, connect the speakers.

Positioning the Speakers

To get the best surround sound effect, place the speakers as follows.

	CENTER
SUB-	SPEAKER	MINI HIFI
FRONT WOOFER		SYSTEM	FRONT
LEFT			RIGHT
	TV
SURROUND			SURROUND
LEFT			RIGHT

order to obtain the best sound.

Test Tone

This feature enables you to adjust the Front Left, Front Right, Center and Surround Sound levels of the respective speakers in Dolby Pro Logic mode.

You must sit at the ideal sitting position and use the remote control to perform this operation.

4Press BALANCE R to adjust the sound of the front right speaker.

ªThe display will show "BAL R +XX".

5Press CENTER +or - to adjust the sound of the center speaker.

ªThe display will show either "CENT +XX or -XX".

6Press REAR + or - to adjust the sound of the surround speakers.

ªThe display will show either "REAR +XX or -XX".

3139 116 19511 ( ENG)