Philips FW-P73 manual 24RECORDING Clock, View Clock Clock Setting

24RECORDING

CLOCK

Dubbing tapes (from tape deck 2 to tape deck 1)

1Load the prerecorded tape into tape deck 2 and a blank tape into tape

deck 1.

•Make sure both tapes have their full spool to the left.

2Press PAUSE on tape deck 1.

3Press RECORD on tape deck 1.

4Press PLAYƒ on tape deck 2. ª The REC starts flashing.

• Recording will start automatically.

5Press STOP•OPEN on tape deck 1 and tape deck 2 to stop dubbing.

Notes:

–At the end of side A, flip the tapes to side B and repeat the procedure.

–Dubbing of tapes is only possible from tape deck 2 to tape deck 1.

–To ensure good dubbing, use tapes of the same length.

Recording from other sources (only on tape deck 1)

1Load a blank tape into tape deck 1.

2Press CD, TUNER or AUX.

•Start playback of the selected source.

3 Press RECORD on tape deck 1 to start recording.

ªThe REC starts flashing.

4Press PAUSE to interrupt recording.

5Press STOP•OPEN on tape deck 1 to stop recording.

Note:

–During recording, it is not possible to listen to another sound source.

MINI HIFI SYSTEM

	PROGRAM SHUFFLE			STEREO		CC
	REPEAT TIMER REC				BACK
	NEWS T.A. AM MW FMLW				FRONT HSD	RR
	60Hz	250Hz 500Hz 1KHz	2KHz 4KHz	8KHz	LL
						PROPRO LOGICLOGIC	DOLBY B
					SS	SS
STANDBY							NR
ON							RDS
CLOCK/	CD1 • 2 • 3	FM • AM			VIDEO		NEWS!
TIMER			TAPE 1 • 2
	CD	TUNER	TAPE		AUX
	PROG			▲	PRESET ▲
	SEARCH • TUNING	STOP • CLEAR PLAY PAUSE		PREV	NEXT
UP
SOUND		SOUND NAVIGATION					VOLUME
DOWN	DIGITAL SOUND		DYNAMIC BASS
	CONTROL		BOOST

View Clock	Clock Setting
You can view the clock (if it is set) if the	The clock can be set in either 12- or
system is in Standby mode or when any	24-hour mode, e.g. “AM 12:00“ or
sound source is selected (CD,TUNER,	“00:00“. Before setting the clock, you
etc.). The clock will be displayed for	must be in the View Clock mode.
about seven seconds.	1 Press CLOCK/TIMER to select
• Press CLOCK/TIMER briefly.	clock mode.

ª“PM 10:38 or 22:38 ” (the 2 Press PROG (on the system only) to

current time) will be displayed		select 12- and 24- hour mode.
depending on whether you have		ª If 12-hour mode is selected, “AM
selected 12- or 24-hour mode.		12:00“ starts flashing.
ª “--:--” will be displayed if the		ª If 24-hour mode is selected,
clock is not set.		“00:00” starts flashing.
	3	Set the hour withʈ or ‡ on the
		system.
	4	Set the minute withÊ’ or ‘ on
		the system.
	5	Press CLOCK/TIMER again to
		store the setting.
		ª The clock starts.

3139 116 19511 ( ENG)