VGA Input, YPbPr Input | Haier LT22R3CBW guide

VGA IN

Connection Instructions

VGA Input

You can use your LCD-TV as a monitor for your personal computer using a VGA cable (not supplied).

Connection and use steps: 1.Read the user guide supplied with

your computer and ensure that it has a VGA connector; 2.Make sure that the power of the LCD -TV and the PC are off;

3.Connect a D type 15-pin VGA interface

cable ( not supplied ) to the VGA video interface connector on the PC. Then connect the other end to the PC video interface connector on the back of the LCD-TV.Tighten the screws on the VGA connectors once they are firmly connected, connect the audio cable(not supplied)to the audio input on the back of your LCD-TV;

4.Turn on the power of the LCD-TV first , and then turn on the power of the PC;

5.Set the video input mode of the LCD-TV to PC;

6.Check the image on your TV. There may be noise associated with the resolution, vertical pattern, contrast or brightness in PC mode. If noise is present, change the PC mode to another resolution, change the refresh rate to another rate or adjust the brightness and contrast on the menu until the picture is clear. If the refresh rate of the PC graphic card cannot be changed,change the PC graphic card or consult the manufacturer of the PC graphic card.

Mode	Resolution	Line frequency (Khz)	Frame frequency (Hz)

VGA	640*480	31.5KHz	60Hz

SVGA	800*600	37.9KHz	60Hz

XGA	1024*768	48.4KHz	60Hz

Note: All above listed are subject to VESA Criteria.

YPbPr Input

How to connect

Connect the DVD video outputs (Y, PB, PR) to the Component(Y, Pb, Pr) in socket on the TV and connect the DVD audio outputs to the AUDIO jacks on the TV, as shown in the figure.

NOTE: If your DVD player does not have component video output, use S-Video.

How to use

1. Turn on the DVD player, insert a DVD.

2. Set the mode of the LCD-TV to Component.