Bosch Appliances E2600 manual Before you begin, Learn about management methods

Page 4

4 en Before you beginE2600 DSA E-Series iSCSI Disk Arrays

1

Before you begin

 

For warnings and detailed installation instructions, refer to the E2600 DSA E-Series

 

Installation manual and additional documentation in the Online Product Catalog on http://

 

www.boschsecurity.com > Video > Digital Recording and Storage > Disk Arrays (Network

 

Attached) > DSA – Disk Arrays > DSA E-Series iSCSI Disk Arrays. (The navigation path is

 

subject to change).

 

Management methods are specific to the installation steps in Section 6 and Section 9.

1.1

Learn about management methods

 

In-band management

 

Management using the I/O connections between the host and the storage. The host must still

 

have Ethernet capabilities.

 

Access volume

 

 

Used to communicate management requests and event information. An access volume is

 

 

needed for only in-band management.

 

Out-of-band management

 

Management directly through the Ethernet connections on each controller using one of the

 

network configurations from the following list (the command line interface CLI might be

 

required):

 

DHCP server

 

 

Permits nodes to dynamically acquire network addresses.

 

Ethernet IP address

 

 

Permits direct connection to controller A or controller B by using an IP address in the

 

 

form of xxx.xxx.xxx.yyy and xxx.xxx.xxx.yyz.

 

Static IP address

 

 

Recommended for out-of-band management using IPv4 networks.

 

Router advertisements

 

 

Recommended for out-of-band management using IPv6 networks.

 

MAC address

 

 

Associates the media address control (MAC) address (xx:xx:xx:xx:xx:xx) of each controller

 

 

with an assigned IP address.

1.2

What you need for assembly

 

E2600 controller-drive tray ship group

 

– One two-unit (2U) -high E2600 controller-drive tray

 

Two power cords

 

– One cabinet mounting hardware kit, including:

 

 

– Two mounting rails (right and left assemblies)

 

 

– Eight M5 x 8 mm screws – Use six screws to secure the mounting rails and two

 

 

screws to secure the front of the controller-drive tray to the cabinet.

– Two M4 x 8 mm screws – Use the screws to secure the rear of the controller-drive tray to the mounting rails.

Options

Drives (two minimum for each controller-drive tray)

DC power cords for the optional –48 VDC power option

If you have any questions about the firmware or your configuration, contact your Customer and Technical Support representative.

Tools

An Internet connection

07/2012 V1

Quick Install Guide

Bosch Sicherheitssysteme GmbH

Image 4
Contents E2600 DSA E-Series iSCSI Disk Arrays Page Table of contents Before you begin Learn about management methodsE2600 DSA E-Series iSCSI Disk Arrays Before you begin en Device view Controller-Drive Tray 12 Drives Front ViewInstall the mounting rails Mounting Rails4Install the controller-drive tray 5Secure the controller-drive tray Controller-Drive Tray 12 DrivesConnect the cables Host-to-Controller CablingE2600 DSA E-Series iSCSI Disk Arrays Connect the cables en En Connect the cables E2600 DSA E-Series iSCSI Disk Arrays Turn on the DC power Power cableEn Turn on the DC power E2600 DSA E-Series iSCSI Disk Arrays Turn on the AC power 9Install and configure the storage array Page Bosch Sicherheitssysteme GmbH