Bosch Appliances E2600 manual Install the mounting rails, Mounting Rails

Page 7

E2600 DSA E-Series iSCSI Disk ArraysInstall the mounting rails en 7

3

Install the mounting rails

 

You can install the drive tray into an industry-standard cabinet.

 

There must be a minimum depth of 76 cm (30 in.) between the front EIA support rails and the

 

rear EIA support rails.

 

1.

Position the mounting rails in the cabinet.

 

 

– If you are installing the mounting rails above an existing tray, position the mounting

 

 

rails directly above the tray.

 

 

– If you are installing the mounting rails below an existing tray, allow 8.9-cm (3.5-in.)

 

 

vertical clearance for the controller-drive tray.

 

2.

Starting with the left mounting rail, use a flat-blade screwdriver to loosen the two flat-

 

 

head rail adjustment screws. Hold the front of the left mounting rail against the inside of

 

 

the front cabinet-mounting flange, and then extend the rear of the mounting rail until it

makes contact with the rear cabinet-mounting flange. The alignment pins at the rear of the mounting rail should slide into the holes at the rear of the cabinet.

1

2

4

3

Figure 3.1: Mounting Rails

1

1Mounting Holes on the Industry-Standard Cabinet

2Adjustment Screws for Locking the Length of the Mounting Rail

3Mounting Rail

4Clip for Securing the Rear of the Controller-Drive Tray

3.From the front of the cabinet, with the mounting-rail flanges inside of the cabinet’s mounting rail assemblies, use the Phillips screwdriver to loosely tighten only the lower screw.

4.From the rear of the cabinet, use the Phillips screwdriver to loosely tighten the two screws. Do not completely tighten the screws until you have installed the controller-drive tray in the cabinet.

5.Repeat step 1 through step 4 for the right mounting rail.

6.Tighten the fl at-head rail adjustment screws on both mounting rails.

Bosch Sicherheitssysteme GmbH

Quick Install Guide

07/2012 V1

Image 7
Contents E2600 DSA E-Series iSCSI Disk Arrays Page Table of contents Learn about management methods Before you beginE2600 DSA E-Series iSCSI Disk Arrays Before you begin en Controller-Drive Tray 12 Drives Front View Device viewMounting Rails Install the mounting rails4Install the controller-drive tray Controller-Drive Tray 12 Drives 5Secure the controller-drive trayHost-to-Controller Cabling Connect the cablesE2600 DSA E-Series iSCSI Disk Arrays Connect the cables en En Connect the cables E2600 DSA E-Series iSCSI Disk Arrays Power cable Turn on the DC powerEn Turn on the DC power E2600 DSA E-Series iSCSI Disk Arrays Turn on the AC power 9Install and configure the storage array Page Bosch Sicherheitssysteme GmbH