Bosch Appliances E2600 manual 5Secure the controller-drive tray, Controller-Drive Tray 12 Drives

Page 9

E2600 DSA E-Series iSCSI Disk ArraysSecure the controller-drive tray en 9

5Secure the controller-drive tray

Warning!

Risk of bodily injury

Do not use equipment in the cabinet as a shelf or work space.

!

1.Secure the screws in the top mounting holes and the bottom mounting holes on each side of the controller-drive tray.

2

1

2

1

Figure 5.1: Controller-Drive Tray (12 Drives)

1

Mounting Holes

2

Screws

2.Secure the rear of the controller-drive tray to the cabinet by using two screws to attach the flanges on each side at the rear of the controller-drive tray to the mounting rails.

3.Install the front end caps on the front of the controller-drive tray by pressing the front end caps into place on the left side and the right side.

Note:

You will install the DE1600 drive trays below and above the controller-drive tray, keeping the weight in the lower portion of the cabinet. You can install a maximum of 192 drives, including the 12 drives in the E2600 controller-drive tray. If needed, refer to E2600 Controller-Drive Tray Installation manual.

Bosch Sicherheitssysteme GmbH

Quick Install Guide

07/2012 V1

Image 9
Contents E2600 DSA E-Series iSCSI Disk Arrays Page Table of contents Learn about management methods Before you beginE2600 DSA E-Series iSCSI Disk Arrays Before you begin en Controller-Drive Tray 12 Drives Front View Device viewMounting Rails Install the mounting rails4Install the controller-drive tray Controller-Drive Tray 12 Drives 5Secure the controller-drive trayHost-to-Controller Cabling Connect the cablesE2600 DSA E-Series iSCSI Disk Arrays Connect the cables en En Connect the cables E2600 DSA E-Series iSCSI Disk Arrays Power cable Turn on the DC powerEn Turn on the DC power E2600 DSA E-Series iSCSI Disk Arrays Turn on the AC power 9Install and configure the storage array Page Bosch Sicherheitssysteme GmbH